ENGLISH
Grooming facial hair (no hair, ear hair and eyebrows)
General description (fig. 1).
A 2D Contour Tracking beard trimmer comb B Trimming attachment C Hair length lector D Relea button E On/off slide F Socket for appliance plug G Cleaning brush H Barber's comb I Charging light J Powerplug K Appliance plug L No/ear/eyebrow attachment M Charging stand with storage facility N Precision attachment (only HQG 267 and QG 3040)
Important.
Read the instructions for u carefully before using the
appliance and save them for future reference.
1 Remove the comb (fig. 9).
2 Remove the trimming attachment (fig. 10).
3 Put the no/ear/eyebrow attachment on the appliance (fig. 13).
A B
C
Trimming no hair
D
E
1 Make sure your nostrils are clean.
F
2 Switch the appliance on and inrt the tip of the attachment into one of your nostrils (fig. 14).
G H
Do not inrt the tip more than 0.5 cm into your nostril.
I
J
3 Slowly move the tip in and out while turning it round at the same time to remove unwanted hair.
To reduce the tickling effect, make sure that the side of the
K L
tip is firmly presd against the skin.
M
N
Trimming ear hair
◗ Check if the voltage indicated on the powerplug
1 Clean the outer ear channel. Make sure it is free from
corresponds to the local mains voltage before you
wax.
connect the appliance. ◗ Only u the powerplug supplied to charge the appliance.
Do not cut off the powerplug to replace it with another plug, as this will cau a hazardous situation.
2 Switch the appliance on and move the tip softly round the ear to remove hairs sticking out beyond the rim of the ear (fig. 15).
◗ ◗
◗ If the powerplug is damaged, always have it replaced by one of the original type in order to avoid a hazard.
3 Carefully inrt the tip into the outer ear channel (fig. 16). ◗ Do not inrt the tip more than 0.5 cm into the ear channel
◗ Make sure the appliance, the charging stand and the powerplug do not get wet.
as this could damage the eardrum.
akyy◗
◗ Charge, u and store the appliance at a temperature
Trimming eyebrows
between 15cC and 35cC.
◗
◗ This appliance is only intended for trimming and grooming the human beard, moustache, sideburns, no hair, ear hair and eyebrows.
U the tip to cut individual eyebrow hairs. ◗kitt
Do not u the appliance to define or trim the entire eyebrow.日耳曼人英语
◗ Keep the appliance out of the reach of children.
Never try to trim your eyelashes.Never come too clo to
◗
◗ Do not u the appliance when one of the attachments your eyes!
◗
is damaged or broken, as this may cau injury.
◗ Do not place the beard trimmer comb on the precision attachment.
1 Place the tip of the attachment on the upper edge of the eyebrow.
◗
various
Charging.
Charge the appliance fully before you start using it for the first time or after a long period of disu.
2 Move it along the edge of the eyebrow from the ba of the no towards the outer tip of the eyebrow (fig. 17).
Cleaning.
It will take approx. 10 hours to fully charge the battery. A fully charged appliance has a cordless operating time of up to 35 minutes.When you charge the appliance for 3 hours, you can u it for 15 minutes.
Do not u water or a moist cloth to clean this appliance.
Do not u abrasives, scourers or liquids such as alcohol, petrol or acetone to clean the appliance.
The appliance does not run from the mains.
1 Remove the comb (fig. 9).
Make sure the appliance is switched off during charging!
2 Remove the attachment (fig. 10).
You can charge the appliance in 2 different ways:
3 Blow and/or shake out any hair that may have
1 In the charging stand:
accumulated in the attachment.
1
◗ Inrt the appliance plug into the socket in the bottom
4 Clean the outside and inside of the attachment with the ◗
of the stand (fig. 2).
brush supplied (fig. 18).
◗ Place the appliance on the pin of the stand (fig. 3).
5 Place the attachment back onto the appliance.
◗
2 Outside the charging stand:
Storage.
2
◗ Inrt the appliance plug directly into the appliance (fig. 4).
◗ The green charging light on the powerplug indicates
◗ Store the appliance and attachments in the stand to
◗
that the appliance is charging (fig. 5).
prevent damage (fig. 19).
Optimi the lifetime of the rechargeable battery
Replacement.
◗
Worn or damaged attachments should only be replaced with
◗ Do not leave the appliance plugged into the wall socket for more than 24 hours.
original Philips replacement attachments, which are available from your dealer or an authorid Philips rvice centre.
◗ Discharge the battery completely twice a year by letting the motor run until it stops.Then fully recharge the
If you have any difficulties obtaining replacement attachments for your appliance, contact the Philips Customer Care Centre
◗
battery.
in your country or consult the worldwide guarantee leaflet.
◗
Preparing for u.
Environment.
◗ Always comb the hair with a fine comb in the direction ◗ Do not throw the appliance away with the normal
of growth before you start trimming.
houhold waste at the end of its life, but hand it in at
◗ Make sure that the hair is dry and clean.
an official collection point for recycling. By doing this
Using the appliance. Beard trimming with comb
you will help to prerve the environment (fig. 20).
◗
The built-in rechargeable battery contains substances that
may pollute the environment. Always remove the battery
◗
1 Put the beard trimmer comb on the trimming attachment and push it home until you hear a click (fig. 6).
before discarding the appliance or handing it in at an official collection point. Dispo of the battery at an official collection point for batteries. If you have trouble removing
2 Press the hair length lector and slide it to the desired the battery, you can also take the appliance to a Philips
tting. See table I (fig. 7). The tting lected will appear in the window to the left of
rvice centre, which will remove the battery for you and will dispo of it in an environmentally safe way.
1
the hair length lector.
B When you are trimming for the first time, start at the
Disposal of the battery
2
maximum trimming length tting (9) to familiari yourlf
with the appliance.
1 Remove the powerplug from the wall socket and pull
B Using tting 1 with the comb installed will result in a
the appliance plug out of the appliance.
'stubble look'.
2 Let the appliance run until the motor stops.
B
3 To trim in the most effective way, move the appliance against the direction of hair growth (fig. 8).
Do not move the appliance too fast. Make smooth and gentle movements and make sure the surface of the comb always
3 Inrt a screwdriver in the groove next to the shaft at the top of the appliance.Turn the screwdriver to parate the two housing halves (fig. 21).
B
stays in contact with the skin.
4 Lift the battery out of the housing by means of a
wasted是什么意思
3
If a lot of hair has accumulated in the comb, remove the comb and blow and/or shake the hair out of the comb.
screwdriver.Twist the connecting wires until they break (fig. 22).
NB:You have to adjust the trimming length again after you have removed the comb!
Do not connect the appliance to the mains again after the battery has been removed.
Beard trimming without comb
Guarantee & rvice. If you need information or if you have a problem, plea visit
1 Remove the comb by pressing and sliding the hair length lector upwards (fig. 9).
Never pull at the flexible top of the comb. Always pull at the bottom part.
the Philips website at or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips
2 Make well-controlled movements and touch your beard Domestic Appliances and Personal Care BV.
only slightly with the trimming attachment.
1
Cutting without the comb will result in a very short stubble beard.
Table 1. Beard trimmer
Setting
Remaining hair length (mm)
Defining beard, moustache and sideburns
1
2
(only HQG 267 and QG 3040)
2
2
4
1 Remove the beard trimmer comb by pressing and
3
6
sliding the hair length lector upwards (fig. 9).
4
8
2 Detach the trimming attachment by pushing the relea
button (fig. 10).国庆节演讲稿
5
10
3 Put the precision attachment on the appliance (fig. 11).
6
12
◗ Hold the appliance upright when you u the precision
7
14
1
attachment (fig. 12).
8
16
9
18
2
c
c
L N K J
I
G
3 ◗
1 2 3 1 2 3
1 2 3
1 2
1 2 3 4 5 ◗
C
A
B
Multitrim
QG3040
H D E
F M
u
4203 000 54845
2
3
4
0.5 cm
5
6
7
8
9
10
11
12
13
14
MAX 5 mm
17
translations15
fgfg16
MAX 5 mm
18
19
20
21
22
2 3
4
◗
1
A B C D E F G H I J K L M N
◗
◗
◗ ◗ ◗
c
◗ ◗ ◗ ◗
1 ◗ ◗ 2 ◗ ◗
◗ ◗
◗ ◗
1 2
B B
3
1
2
2 3 ◗ 1 2 3 1 2
3
1 2 3
c
1 2
1 2 3 4 5 ◗
◗
1 2 3 4
C
A
L N K J
I
G
2
B
hint
H D E
F M
3
4
5
6
7
8
9
10
11
12
13
14
MAX 5 mm
17
15
16
MAX 5 mm
18
19
姐姐的守护者 下载
20
21
22
