沉香属
STCW-Deck-operational-bulk carrier
1.Operator connected R/T calls are charged
On the basis of a three minutes minimum charge with one minute incremental steps
2.If a DSC distress alert is received on board your ship, what is the first action that should be taken?
职场英语
Listen for a distress message on the appropriate radio frequency for five minutes
3.What signal, if any, is specified in SOLAS as the “Abandon ship” signal?
The “Abandon ship” signal is not specified, only the general emergency alarm signal is stated.
4.What does ISM stand for?
The International Management Code for the Safe Operation of Ships and for Pollution Prevention
5.Which type of equipment can be ud to detect explosives?
Particulate detector
6.Carrying coal with a high Sulphur content in bulk could result in
Corrosion of steelwork in the cargo holds if the cargo becomes wet
06年世界杯主题曲7.The CO2 injection lines into the designated ballast hold of a bulk carrier are aled
外研社小学英语
Prior to ballasting the gold图片的英文
8.Is the location of a vesl’s standard compass binnacle critical?
Yes, for the reason stated in all of the suggested answers.
9.What would you call the wreckage of a yacht floating in the a?
Flotsamvsp
10.Before a bulk carrier can load a full cargo of grain, what additional stability information is required?
Grain loading conditions must be shown and the vesl is in posssion of a Document of Authorization
11.Which option correctly identifies the meaning of the abbreviation ZOC, in relation to ECDIS?
Zone of Confidence
12.What is meant by the term ‘bunkers’?
It means fuel oil ud in the main engine(s)
13.What do you understand by the term “Let Go” when applied to mooring and unmooring?
Let Go means to cast off the mooring ropes and wires
14.What is the output shown on the “Rate of Turn” indicator fitted on the bridge?
The Rate of Turn indicator displays the rate the ship is swinging in degrees per minute
15.According to basic principles regarding fire protection the ship is to be divided in zones by structural and thermal boundaries. (SOLAS Ⅱ-2/2.2.1)
In main vertical zones
16.Two ships are meeting in a restricted channel as illustrated. Which of the following actions would be the most suitable to take on both vesls as they approach and pass each other?
Slow down if possible without losing steerage and be prepared for prompt application of rudder to counteract any swing as they approach and pass each other.
17.A ship is turning slowly with the rudder hard over and the propeller stopped. What can be done to increa the rate of turn but not the forward speed?
Give the engine a short full ahead.
18.第二学位怎么报名Which position is the best to stop bleeding from the no?
Sitting on a chair, leaning forward, with two fingers pressing the no together.
19.A wire aerial for an MF/HF-transmitter must be suspended between isolators:
To prevent contact with earth
线上小游戏20.To prevent overload of the MF/HF transmitter;
Clean the dust filter of the fan regularly
21.Which action do you perform when you log in to a satellite ocean region?
You inform the NCS that the SES is available for communications.
22.“On area A2 the function” ”Transmission and reception of on scene communications” “is mainly bad on:”
The u of MF and/or VHF R/T
23.When a fire breaks out in the accommodation, cargo holds or on deck, who is in charge of the fire fighting operations?
新东方英语论坛The person who is designated in the muster list
24.How is a Safety Management Certificate obtained?
Ship owner has Document of Compliance issued, and vesl is assd and holds all statutory certificates
25.What is the minimum number of immersion suits that are required to be provided for each open lifeboat under SOLAS rules?
One for each person
26.Rerve Buoyancy is:
The buoyancy provided by all enclod spaces above the waterline
27.A good indicator of the possibility of cargo damage on a bulk carrier is
The prence of hatch cover aling tapes
28.The hatch cover hydraulic system of a bulk carrier can be damaged by
Dust and cargo particles around the piston als
29.How can an approximate value of the initial transver Metacentric Height (GM) be found from the Curve of Statical Stability (GZ curve)?
Drawing a tangent to the curve through the origin and erecting a perpendicular through the angle of heel of 57.3 degrees
