Triple-Lok® 37° Flare Tube Fittings and Adapterspoliceman是什么意思
rfa
The Fitting Authority
Conversion Adapters (Shown in Sections K and L)
Diagnostic and Orifice Fittings (Shown in Section N)
wlan怎么读>gidget
O-Rings and Seals (Shown in Section O)
五月英文Introduction
Parker pioneered the flare fitting concept early in the early 20th century. The design has since gained worldwide acceptance due to it’s many inherent features and customer benefits.Today, the 37° flare fitting it is the most widely ud fitting in the world. Its appeal is in its simplicity, compact design, ea of asmbly, reliability (single al), material availability, adapt-ability to inch or metric tube, worldwide availability and accep-tance. Further helping its acceptance is its widespread u as a ho adapter. As a tube fitting, it is especially suited for thin and medium wall thickness tube. Even though 37° flare fittings are generally considered to be 3000 psi fittings, Triple-Lok’s capabilities range from 9000 psi for 1/4" size to 2000 psi for 2"size. Currently, it is ud in virtually every application that us fluid power for motion control.
Parker’s Triple-Lok fittings meet the strict requirements of SAE J514 and ISO 8434-2 industry standards. Additionally, they meet many customer and industry-recognized conformance standards and type approvals.
Design and Construction生气的意思
The Triple-Lok (37° flare fitting) design is simple. It us an easily produced flare at the tube end to al and hold fluid under high pressure. The fitting consists of three pieces: the body,sleeve and nut.
The tube end is flared at a 37° angle (74°included angle) and held between the fitting no (at) and the sleeve (support) with the nut as shown in Fig. C2, providing a very effective (single) al between the fitting no and the tube flare.p t
The design of Triple-Lok fittings is very efficient. The fitting incorporates the smallest al area of all fitting types. This al area, as en in Fig. C2, is only slightly larger than the fluid flow area. The small al area results in a compact design, low asmbly torque, and a relatively high-pressure capability.The primary difference between a two-piece flare fitting and the three-piece design is the flare support sleeve. The support sleeve provides veral key functions:
1.It provides a clamping surface for the tube flare.
2.It provides a bearing surface for the tube nut. The sleeve
isolates the tube from the nut, minimizing the tube twist during asmbly, a common problem of 2-piece flare fitting designs.
dot
3.It provides support to the tube flare. The tapered fittingdo
no tends to “wedge open” the tube flare during asm-bly. The sleeve helps to resist this expansio
秘密花园16n, thus elimi-nating the possibility of tube flare and sleeve jamming inside the nut. This eliminates any waste of applied torque and allows for easy disasmbly.
4.It makes the fitting adaptable to metric tube merely by
changing its inside diameter (e Table C2).Due to the popularity and simplicity of the 37° flare fitting, many manufacturers offer the product. Even though most manufac-turers conform to the same dimensional standards, there are significant performance advantages with Parker’s Triple-Lok fittings due to Parker’s optimized manufacturing methods and commitment to quality.
Fig. C1 – Triple-Lok Fitting Body, Sleeve and Nut
Sleeve
Clamping and
Sealing Surface of tube flare against body no
Flare Support
resisting “opening”of flare
Bearing Surface
Small al area allows for adequate clamping load applied with relatively low asmbly torques
Fig. C2 – Triple-Lok Design and Features
Flared Tube
Seal
