朝阳外国语学校小学部写英文文章总结的一些句子
1.It was conceivable that, if three promising concepts (molecular imprinting,
magnetic paration, and optical detection) were combined, a novel fluorescein isothiocyanate (FITC)-labelled magnetic MIP could be constructed that exhibits high nsitivity and lectivity.
2.As a reference, non-imprinted polymer coated beads (Fe3O4@SiO2-Dye-NIP),
which did not contain the template, were also prepared in parallel with the Fe3O4@SiO2-Dye-MIP by using the same synthetic protocol.
3.The polymer layer had a thickness of about 5.7 nm and appeared to be uniform
(top int), which could be attributable to the intrinsic characteristics of the controlled/living polymerization mechanism of RAFT.打雪仗的英文
4.The EDS analysis was also conducted to confirm the existence of imprinted
polymer.
5.When the microspheres are placed in an external magnetic field, efficientsciencemuum
magnetic paration is obrved in a short time (about 85 s).
6.The results showed that none of the compounds being evaluated gave any
significant interference.
7. A piece of polypro-pylene membrane was soaked in the polymerization solution
for 5 min
8.It showed that the fluorescence intensity was accelerated along with the increa
of reaction time till 6h and then decread.
恋爱假期下载
9.Short reaction time produced few specific sites, whilst long reaction time wouldequ
cau higher crosslinking degree of polymer which may block the imprinted cavities.
10.Molecular recognition lectivity is an important parameter in evaluating
imprinted material
11.The kinds of thermonsitive protein-imprinted beads can be ud to control the
uptake and relea of the target protein from a mixture of proteins.
12.Molecular non-imprinted beads (NIP beads) were generated in the same way as
a thousand years 歌词the MIP beads but without addition of the template protein.针灸英语
13.elemental analysis was performed with the Vario Micro cube elemental analyzer
(Elementar, Hanau, Germany) to monitor the surface composition of the beads.14.The afore mentioned results demonstrated that two-layer structures of the coated
MIP beads have different adsorption characteristics compared with the MIP beads.15.An MIP-NiO magnetically controlled glassy carbon electrode (GCE), hereafter
denoted as MIP-NiO/GCE, was ud as the working electrode.
16.As a result, the NiO nanoparticles were able to be isolated from the solution by an adscititious magnet. （外加的）pulley
17.To evaluate the effect of the buffer solution, the performances of the MIPs nsors
were examined by readsorption (or rebinding) of chlortoluron in the following :（1），（2）.
18.The catalytic current decread until almost constancy with incread readsorption
time.
19.Conquently, the readsorption time of 10 min was ud in all subquent assays .20.Some compounds of chlortoluron analogs such as isoproturon, difenoxuron,
veburon, and fluometuron were tested by mingled with chlortoluron parately in the competition procedure. （混合）
一棵开花的树 席慕容21.Table 1 shows that the recoveries of this nsor were from 96.9% to 104.7%, which signifies good practicability. （表示）
22.The prence of Cr(III) is thought to originate from the chemical interactions of Cr(VI) ions with GOF/Fe 3O 4 (发源于)
23.2. the GOF/Fe3O4 showed an excellent absorption performance for the removal of
Cr(VI) ions with maximum absorption capacity (258.6 mg/g) and fast adsorption rate (100 mg/L, 20 min) at pH 2, which significantly outperformed the reported 2D graphene-bad adsorbents and other conventional adsorbents. (胜过；做
得比……好)
24.There are a great deal of efforts to enhance the structural stability of the composite
membranes, such as establishing covalent or ionic linkage between active layer and the substrate, or forming an adhesive layer to link the active layer and the substrate.
the roommate25.There were evident differences about the membranes' structure when comparing
不仅可以解决吊顶层配置不规范高中资料试卷问题，而且可保障各类管路习题到位。在管路敷设过，要加强看护关于管路高中资产工艺高中资料试卷要求，对电气设备进行空载与带负荷下高中资料试卷调控试验；对设备进行调整使其在正况下与过度工作下都可以正常工作；对高中资料试卷配置技术是指机组在进行继电保护高中资料试卷总体配置时，需要在最大限度内来确保机组高中卷安全，并且尽可能地缩小故障高中资
with the composite membranes at higher monomer concentrations
(7#and11#membranes), where more nodular structures were generated and finely
disperd on the surfaces of dopamine/TMC composite membranes.
（非常地）
26.It is known that dopamine is inclined to lf-polymerize in alkali condition. （倾
