应收票据 600T套筒窑BASK 161开窑细节
Kiln charging with material
石灰窑上料原料
1 The stones must be clean and dry and in the size from 10 - 20mm ( no sand)
nail up
The dischrge tables have to be filled with limestone bags until the kiln is filled with 2/3 mt.of limestone.
石灰石必须为干净的，干燥的，尺寸为10-20mm（不含沙）
出灰装置用编织袋覆盖知道小颗粒石灰石达到窑内的 2/3 mt
莎士比亚的十四行诗
2 The kiln has to be charged with this small material over the upper bridges
before start with the charging all thermocouple on comb.chambers have to be pulled back 100mm for safety.
小颗粒石灰石一直上到石灰窑上拱桥以上。
为了安全起见，在上料之前，把所有的热电偶往后拉100mm
辞职信 范本3 During the charging , the discharging has to work all 10 min ( one stroke)
在上料期间，卸料要持续运行10分钟（一个冲程）
raining sunshine4 Control of the single discharge tables by checking the movement inside the kiln ( over the upper man hole)
when the material will be 1mt. Below the upper man hole.
检查窑内运行状态，通过控制每个出灰装置，使料超过上拱桥，到达上部人孔下方1米处。
5 Before the ignition can be done the small material has to change into the normal size , if the
big material has reached the discharge tables the kiln is ready for ignition
点火之前，应把小颗粒石灰石置换成大颗粒石灰石，如果大颗粒石灰石到达出灰装置，那么就说明满足点火的条件。
6 In the same time where the kiln is filling up with the normal size the upper man hole has to be clod
滑稽的反义词 在石灰窑内填满大颗粒的石灰石，关闭上部人孔
7 The kiln has to charged to the kiln top and the level meter has to adjust
填料到窑顶，校正料位计
8 If the level meter is adjusted the complete charging quence has to check and run
校正完料位计，检查并运行上料步骤
9 Control the movement of limestone on the combustion chambers
控制燃烧室内石灰石的状态
10 Adjust the timer for the discharge system
校正出灰系统运行时间
11 Control of the correct working of the discharge tables and check the correct movement of each discharge stroke
控制出灰装置在正常运行状况下，并检查每个出灰冲程是否正确运行
12 All cold tests must be finished and all quences has to work in "AUTOMATIC"
完成所有冷试工作，确保每个工作步骤在自动控制下
13 After the kiln is ready to ignition , he must heated up according agreed heating up curve
当石灰窑具备点火条件后，必须按照规定的升温曲线来运行
14 Heating up curve has to discusd and confirmed by both parties ( proposal for heating up curve over handed to
BASK 161 on20-08-2009 client on 20-08-2009)
双方讨论并确认升温曲线（此升温曲线在09年8月20日已经递交）
General points for ignition:
terminal是什么意思 点火注意事项
A) Every shift to operators must be on site also 1 electrical and 1 mech. Person must available
winter sweet 现场每班必须配备一个电气操作人员和一个机械操作人员，保持待命状态。
B) Limestone must available in the correct amount and size
确保提供的石灰石，数量和大小方面符合要求。
C) Gas must be available in the correct amount , composition , heat value and pressure
确保电石炉尾气，数量，成分，热值，压力值符合要求。
D) TF personal will stay over the day time on site to make all adjustment on the kiln , TF personal will give
instruction for the night shift . In ca of big problems TF personal is available t
o come on site 24 h a day
to solve the problems . Baoye has to organi transport and Interpreter if necessary
TF服务人员将在白天上班并安排相关事宜，他们在夜班时将给出指导和建议安排。如果一旦发生特殊情况，TF公司人员将每天24小时保持待命状态并解决问题。宝冶将负责接送并尽可能提供现场翻译。
E) The new gas composition and also the modified heating up curve has to confirmed by TF management before start of the kiln
在开窑之前，如果新的燃气成分发生变化并修改升温曲线，需得到TF管理人员的确认。
F) The emergency power supply has to check before start the kiln and also the operator has to be informed how to handle
在开窑之前要检查应急电源供应并告知操作人员怎样使用它
dream是什么意思
G) Cleaning tools has to be on the kiln , also the ignition lances must be installed on the lower burners
石灰窑上必须配备清理工具，并检查点火枪是否安装在下烧嘴
I) The charging system must work in "Automatic mode " in a stable mode and the charging equipment must proper adjusted
确保上料系统必须在自动模式下运行，并检查上料设备是否正确安装并调整。
If the described points are fulfilled the kiln is ready for start.
如果石灰窑具备以上条件，就说明达到开窑条件。
公主与青蛙
