() Preliminary Specification (V ) Final Specification
Module 19.5” Color TFT-LCD Model Name
M195RTN01.0
Customer
Date
Approved by
Note: This Specification is subject to
change without notice.
Approved by Date
Howard Lee
Mar 25, 2013
Prepared by Date
Eric Lee
Mar 25, 2013
AU Optronics corporation
A U
O
C
without you 歌词
o n f
i d
e n t
i a l
F o
r S
T A
R I n t e
r n
a l U
s e
fraxO n l
y / 2
01
3/
4/
25
Contents
1 4 2 General Description (5)
2.1 .5 2.2 Absolute Maximum Rating of Environment ...........................................................................6 2.3 .7 3 TFT-LCD Module. (11)
3.1 11 3.2 Interface Connection.. (12)
3.2.1 12 3.2.2 Connector 12 3.3 Electrical Characteristics.. (14)
3.3.1 Absolute Maximum Rating (14)
3.3.2 Recommended 14 3.4 Signal Characteristics. (15)
3.4.1 LCD Pixel Format (15)
3.4.2 LVDS 15 3.4.3 Color versus .16 3.4.4 17 3.4.5 Input Timing Specification (19)
3.4.6 Input 20 3.5 Power ON/21 4 Backlight Unit. (22)
4.1 Block Diagram (22)
4.2 Interface Connection (23)
4.2.1 23 4.2.2 Connector Pin Assignment. (25)
4.3 Electrical Characteristics (26)
4.3.1 Absolute 26 4.3.2 Recommended Operating Condition. (26)
5 Reliability Test (28)
6 .29 7 Mechanical Characteristics .....................................................30 8 Packing Specification.. (31)
8.1 31 8.2 Pallet and shipment information (32)
A U
O
C
o n f
i d
e n t
i a l
F o
r S
T A
R I n t e2012年高考数学试题
r n
a l U
s e
O n l
y / 2
01
3/
4/
25
Record of Revision
Version
Date
Page
Old description
New Description
Remark
0.1 2013/1/19 All First version relea -
1.0 2013/3/25 19 Input timing spec Modify Input timing spec
1.0 2013/3/25 5 Pixel Arrangement RGB Island
Pixel Arrangement RGB
Vertical Stripe
1.0 2013/3/25 5 VDD line: PDD type (typ)
2.5W VDD line: PDD type (typ)
3.0W
argus
1.0 2013/3/25 14 Table 3.3.2 Table 3.3.2 IDD & PDD
A U
O
C
o n f
i d
e n t
i a l
F o
r S
T A
R I n t e
r n
a l U
s e
O n l
y / 2
01
3/
4/
25
1 Handling Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inrting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cau discoloration or spots. 4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface. 6) Since CMOS LSI is ud in this module, take care of static electricity and insure human earth
when handling.
7) Do not open or modify the Module Asmbly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In ca a TFT-LCD Module has to be put back into the packing container slot after once it was
taken out from the container, do not press the center of the LED lightbar edge. Otherwi the TFT-L
CD Module may be damaged.
10) Inrt or pull out the interface connector, be sure not to rotate nor tilt it of the TFT-LCD
Module.
11) Do not twist nor bend the TFT -LCD Module even momentary. It should be taken into
consideration that no bending/twisting forces are applied to the TFT-LCD Module from outside. Otherwi the TFT-LCD Module may be damaged.
12) Plea avoid touching COF position while you are doing mechanical design.
13) When storing modules as spares for a long time, the following precaution is necessary:
在线英汉互译词典
Store them in a dark place. Do not expo the module to sunlight or fluorescent light. Keep the temperature between 5℃ and 35℃ at normal humidity.
A U
O
C
o n f
i d
e n t
i a l
F o
r S
T A
R I n t e
r n
a l U
s e
O n l
y / 2
01
3/
4/
25
2 General Description
This specification applies to the19.5 inch wide Color a-Si TFT-LCD Module M195RTN01.0. The display supports the HD+ - 1600(H) x 900(V) screen format and 16.7M colors (RGB 6-bits + Hi-FRC data). The input interface is Dual channel LVDS and this module doesn’t contain an driver board for backlight.
2.1 Display Characteristics
The following items are characteristics summary on the table under 25 condition:底特律警察
ITEMS
Unit SPECIFICATIONS Screen Diagonal [mm] 495.3 (19.5”)
Active Area [mm] 433.92(H) x 236.34 (V) Pixels H x V - 1600(x3) x 900 Pixel Pitch
[um] 0.2712 x 0.2626
Pixel Arrangement - R.G.B. Vertical Stripe Display Mode
-
TN Mode, Normally White White Luminance ( Center ) [cd/m 2
] 250 (Typ.) Contrast Ratio - 1000 (Typ.) Respon Time
[mc] 5 (Typ., on/off)
Power Consumption
(LCD Module + Backligh unit) [Watt]
LED line : PBLU (typ) = 7.44 W VDD line : PDD (typ)= 3.0 W
Weight
[Grams] 1430 Outline Dimension [mm] 452.0(H)x263(V)x10.5(D) Electrical Interface - Dual channel LVDS Support Color广州新东方
- 16.7M colors (RGB 6-bit + Hi_FRC ) Surface Treatment - Anti-Glare, 3H Temperature Range Operating
initStorage (Shipping) [o C] [o C] 0 to +50 -20 to +60 RoHS Compliance - RoHS Compliance TCO Co
mpliance
- TCO 6.0 Compliance
A U
O
C
o n f
i d
e n t
i a l
F o
r S
T A
R I n t e
r n
a l U
s e
O n l
y / 2
01
3/
4/
25
2.2 Absolute Maximum Rating of Environment
Permanent damage may occur if exceeding the following maximum rating.
Note 2-1:Temperature and relative humidity range are shown as the below figure.
1. 90% RH Max ( Ta ≦39℃)
2. Max wet-bulb temperature at 39℃ or less. ( Ta ≦39℃)
3. No condensation
Operating Range Storage Range
Symbol Description Min. Max. Unit Remark
TOP Operating Temperature 0 +50 [o C] Note 2-1
TGS Glass surface temperature
(operation) 0 +65 [o C]
Note 2-1
Function judged only HOP Operation Humidity 5 90 [%RH]
TST Storage Temperature -20 +60 [o C]
HST Storage Humidity 5 90 [%RH]
Note 2-1 A
U
O
C
o
n
f
i
d
e
n
t
i
a
l
F
o
r
S
T
A
R
I
n
t
e
r
n
a
l
U
美丽 英文
s
e
O
n
intexl
y
/
2
1
3
/
4
/
2
5
