IR2103(S)PBF
Half-Bridge Driver
感恩节的由来英文版
dramaqueenFeatures
∙ Floating channel designed for bootstrap operation ∙ Fully operational to +600V
xxyy∙ Tolerant to negative transient voltage ∙ dV/dt immune
∙ Gate drive supply range from 10 to 20V ∙ Undervoltage lockout
∙ 3.3V, 5V and 15V logic compatible ∙ Cross-conduction prevention logic
∙ Matched propagation delay for both channels ∙ Internal t deadtime
西海岸是什么意思you a∙ High side output in pha with HIN input ∙
Low side output out of pha with LIN input
Description
The IR2103(S) are high voltage, high speed power MOSFET and IGBT drivers with dependent high and low side referenced output channels. Proprietary HVIC and latch immune CMOS technologies enable ruggedized monolithic construction. The logic input is compatible with standard CMOS or LSTTL output, down to 3.3V logic. The output drivers feature a high pul current buffer stage designed for minimum driver cross-conduction. The floating channel can be ud to drive an N-channel power MOSFET or IGBT in the high side configuration which operates up to 600 volts.
Ordering Information
fnacProduct Summary
Package Options
Typical Connection Diagram
Absolute Maximum Ratings
Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. All voltage parameters are absolute voltages referenced to COM. The thermal resistance and power dissipation ratings are measured under board mounted and still air conditions.
五年级上册英语试卷
curly
Recommended Operating Conditionsrumored
The input/output logic timing diagram is shown in figure 1. For proper operation the device should be ud within the recommended conditions. The V S offt rating is tested with all supplies biad at 15V differential.
†Logic operational for V S of -5 to +600V. Logic state held for V S of -5V to -V BS. (Plea refer to the Design Tip DT97-3 for more details).
Dynamic Electrical Characteristics
via是什么意思V BIAS (V CC, V BS) = 15V, C L = 1000 pF and T A = 25°C unless otherwi specified.
Static Electrical Characteristics
V BIAS (V CC, V BS) = 15V and T A = 25°C unless otherwi specified. The V IN, V TH, and I IN parameters are referenced to COM. The V O and I O parameters are referenced to COM and are applicable to the respective output leads: HO or LO.