1/14
October 2004
s INPUT VOLTAGE FROM 2.5V TO 6V s
STABLE WITH LOW ESR CERAMIC CAPACITORS
s
ULTRA LOW DROPOUT VOLTAGE (100mV TYP . AT 150mA LOAD, 0.4mV TYP. AT 1mA LOAD)
s
VERY LOW QUIESCENT CURRENT (85µA TYP . AT NO LOAD, 170µA TYP . AT 150mA LOAD; MAX 1.5µA IN OFF MODE)
s
GUARANTEED OUTPUT CURRENT UP TO 150mA
s
WIDE RANGE OF OUTPUT VOLTAGE: 1.2V; 1.22V; 1.25V; 1.35V; 1.5V; 1.8V; 2V; 2.1V; 2.2V; 2.4V; 2.5V; 2.6V; 2.7V; 2.8V; 2.85V; 2.9V; 3V; 3.1V; 3.2V; 3.3V; 4.7V; 5V
s
FAST TURN-ON TIME: TYP . 200µs [C O =1µF, C BYP = 10nF AND I O =1mA]
s
LOGIC-CONTROLLED ELECTRONIC SHUTDOWN
s INTERNAL CURRENT AND THERMAL LIMIT s
OUTPUT LOW NOISE VOLTAGE 30µVRMS OVER 10Hz to 100KHz
s S.V.R. OF 60dB AT 1KHz, 50dB AT 10KHz s
TEMPERATURE RANGE: -40°C TO 125°C
DESCRIPTION
The LD3985 provides up to 150mA, from 2.5V to 6V input voltage.
The ultra low drop-voltage, low quiescent current and low noi make it suitable for low power applications and in battery powered systems.Regulator ground current increas only slightly in dropout, further prolonging the battery life. Power supply rejection is better than 60 dB at low frequencies and starts to roll off at 10KHz. High power supply rejection is maintained down to low input voltage levels common to battery operated circuits. Shutdown Logic Control function is available, this means that when the device is ud as local regulator, it is possible to put a part of the board in standby, decreasing the total power consumption. The LD3985 is designed to work with low ESR ceramic capacitors. Typical applications are in mobile phone and similar battery powered wireless systems.
LD3985SERIES
ULTRA LOW DROP-LOW NOISE BICMOS VOLTAGE REGULATORS LOW ESR CAPACITORS COMPATIBLE
Rev. 8
LD3985 SERIES
2/14
Table 1: Absolute Maximum Ratings
Absolute Maximum Ratings are tho values beyond which damage to the device may occur. Functional operation under the condition is not implied.
(*) The input pin is able to withstand non repetitive spike of 6.5V for 200ms.
Table 2: Thermal Data
Table 3: Order Codes
(*) Available on request.
Symbol Parameter
Value Unit V I DC Input Voltage -0.3 to 6 (*)V V O DC Output Voltage -0.3 to V I +0.3V V INH INHIBIT Input Voltage -0.3 to V I +0.3V
I O Output Current Internally limited P D Power Dissipation
Internally limited T STG Storage Temperature Range
-65 to 150°C T OP
Operating Junction Temperature Range
-40 to 125
°C Symbol
Parameter
SOT23-5L/TSOT23-5L
Flip-Chip
broom是什么意思
Unit R thj-ca Thermal Resistance Junction-ca 81°C/W R thj-amb
Thermal Resistance Junction-ambient
255
170°C/W
SOT23-5L TSOT23-5L Flip-Chip OUTPUT VOLTAGES
LD3985M12R (*)LD3985G12R (*)LD3985J12R (*) 1.20 V LD3985M122R LD3985G122R (*)LD3985J122R 1.22 V LD3985M125R (*)LD3985G125R (*)LD3985J125R 1.25 V LD3985M135R (*)LD3985G135R (*)LD3985J135R 1.35 V LD3985M15R LD3985G15R (*)LD3985J15R (*) 1.5 V LD3985M18R LD3985G18R LD3985J18R 1.8 V LD3985M20R (*)LD3985G20R (*)LD3985J20R (*) 2.0 V LD3985M21R (*)LD3985G21R (*)LD3985J21R (*) 2.1 V LD3985M22R (*)LD3985G22R (*)LD3985J22R (*) 2.2 V LD3985M24R (*)LD3985G24R (*)LD3985J24R 2.4 V LD3985M25R LD3985G25R LD3985J25R 2.5 V LD3985M26R (*)LD3985G26R (*)LD3985J26R 2.6 V LD3985M27R LD3985G27R LD3985J27R 2.7 V LD3985M28R (*)LD3985G28R (*)LD3985J28R 2.8 V LD3985M285R (*)LD3985G285R (*)LD3985J285R (*) 2.85 V LD3985M29R LD3985G29R LD3985J29R 2.9 V LD3985M30R (*)LD3985G30R (*)LD3985J30R 3.0 V LD3985M31R (*)LD3985G31R (*)LD3985J31R 3.1 V LD3985M32R (*)LD3985G32R (*)LD3985J32R (*) 3.2 V LD3985M33R LD3985G33R (*)LD3985J33
R 3.3 V LD3985M44R (*)LD3985G44R (*)LD3985J44R (*) 4.4 V LD3985M47R LD3985G47R (*)LD3985J47R 4.7 V LD3985M48R (*)LD3985G48R (*)LD3985J48R 4.8 V LD3985M49R (*)LD3985G49R (*)LD3985J49R (*) 4.9 V LD3985M50R (*)
LD3985G50R (*)
LD3985J50R (*)
5.0 V
LD3985 SERIES
3/14
Figure 2: Connection Diagram (top view for SOT and TSOT, top through view for Flip-Chip)
Table 4: Pin Description
Figure 3: Typical Application Circuit我是歌手第二季歌单
Pin N°SOT23-5L/TSOT23-5L
Pin N°Flip-Chip
Symbol Name and Function
cherry是什么意思14V I Input Voltage of the LDO
22GND Common Ground
31V INH Inhibit Input Voltage: ON MODE when V INH ≥ 1.2V, OFF MODE when V INH ≤ 0.4V (Do not leave floating, not internally pulled down/up)
45BYPASS Bypass Pin: Connect an external capacitor (usually 10nF) to minimize noi voltage
5
teacher3
V O
Output Voltage of the LDO
LD3985 SERIES
ggl4/14
Table 5: Electrical Characteristics For LD3985 (T j = 25°C, V I = V O(NOM) +0.5V, C I = 1µF,C BYP = 10nF, I O = 1mA, V INH = 1.4V, unless otherwi specified)
Symbol Parameter
Test Conditions
Min.Typ.
Max.Unit V I Operating Input Voltage 2.56V V O Output Voltage < 2.5V I O = 1 mA -5050mV
T J = -40 to 125°C -7575V O Output Voltage ≥ 2.5V I O = 1 mA -22% of V O(NOM)T J = -40 to 125°C
-33∆V O Line Regulation (Note 1)V I = V O(NOM) + 0.5 to 6 VT J = -40 to 125°C -0.10.1%/V V O = 4.7 to 5V -0.19
0.19∆V O Load Regulation I O = 1 mA to 150mA V O < 2.5V
T J = -40 to 125°C
0.0020.008%/mA ∆V O
Load Regulation
I O = 1 mA to 150mA V O ≥ 2.5V T J = -40 to 125°C (for Flip-Chip)0.00040.002%/mA I O = 1 mA to 150mA, T J = -40 to 125°C (for SOT23-5L/TSOT23-5L), V O ≥ 2.5V
0.00250.005
bec考试报名时间
∆V O Output AC Line Regulation V I = V O(NOM) + 1 V, I O = 150mA,
t R = t F = 30µs 1.5mV PP I Q
Quiescent Current
ON MODE: V INH = 1.2V
I O = 085
µA I O = 0
T J = -40 to 125°C
150
I O = 0 to 150mA 170
I O = 0 to 150mA
T J = -40 to 125°C
250OFF MODE: V INH = 0.4V
0.003
T J = -40 to 125°C
1.5
V DROP杭州咖啡培训
Dropout Voltage (NOTE 1)I O = 1mA
0.4
迈克杰克逊专辑
mV
I O = 1mA
T J = -40 to 125°C
2I O = 50mA 20
I O = 50mA T J = -40 to 125°C
35I O = 100mA 45
I O = 100mA T J = -40 to 125°C
70
I O = 150mA 60
I O = 150mA
T J = -40 to 125°C
100
I SC Short Circuit Current R L = 0
600mA SVR
Supply Voltage Rejection
V I = V O(NOM)+0.25V ±V RIPPLE = 0.1V, I O = 50mA V O(NOM) < 2.5V, V I = 2.55V f = 1KHz 60dB
f = 10KHz 50I O(PK)Peak Output Current V O ≥ V O(NOM) - 5%300
550
mA V INH Inhibit Input Logic Low V I = 2.5V to 6V T J = -40 to
125°C 0.4
V
Inhibit Input Logic High 1.2
I INH Inhibit Input Current V INH = 0.4V V I = 6V
±1nA eN Output Noi Voltage B W = 10 Hz to 100 KHz
C O = 1 µF
30µV RMS t ON Turn On Time (Note 4)C BYP = 10 nF 100250
µs T SHDN
Thermal Shutdown
Note 5
160
°C
LD3985 SERIES
5/14
O(NOM)I Note 2 – For V O(NOM) = 1.25V, V I = 2.5V
Note 3 – Dropout voltage is the input-to-output voltage difference at which the output voltage is 100mV below its nominal value. This speci-fication does not apply for input voltages below 2.5V.
Note 4 – Turn-on time is time measured between the enable input just exceeding V INH High Value and the output voltage just reaching 95% of its nominal value
Note 5 – Typical thermal protection hysteresis is 20°C
Note 6 - The minimum capacitor value is 1µF, anyway the LD3985 is still stable if the compensation capacitor has a 30% tolerance in all temperature range.
the catcher in the ryeTYPICAL PERFORMANCE CHARACTERISTICS (T j = 25°C, V
I = V O(NOM) +0.5V, C I = C O = 1µF,C BYP = 10nF, I O = 1mA, V INH = 1.4V, unless otherwi specified)Figure 4: Output Voltage vs Temperature
enoFigure 5: Output Voltage vs Temperature Figure 6:
Output Voltage vs Temperature
Figure 7: Shutdown Voltage vs Temperature
C O
Output Capacitor
Capacitance (Note 6)122µF ESR
5
5000
m Ω
Symbol Parameter
Test Conditions
Min.Typ.Max.
Unit
