物质安全资料表（MSDS）
Material Safety Date Sheet 一、产品和公司说明Instruction of Product and Company
产品名称Product Name 无铅锡条
Lead-free Solder Bar
产品代号
Product code
107H
产品成分
cider
Product composition
Sn-0.7Cu
产品类型Product Type 固态solid
供应商Supplier 地址Address
联系电话TEL.传真FAX.
二、产品成分/数据Product Composition/Data
三、危险说明Hazard Declaration
紧急情况Emergence 高温焊料可能灼伤眼睛和皮肤。焊接过程中所产生烟雾对眼睛和呼吸系统会产生刺激作用。
The eyes and skin may be burnt by the high temperature solder.Stimulation to eyes and
respiratory system can be made by Smoke produced by welding process.
主要途径
Main routes□皮肤(Skin)□食入(Ingestion)■吸入(Inhalation)■眼睛(Eye)
影响对象Objects affected 不适用。Not suitable.
潜在的健康效应（短期接触）Potential health effects(Short-term contact)
bloomington皮肤For Skin 可能使皮肤有轻微的过敏现象。高温熔融焊料可灼伤皮肤。
The eyes and skin may be burnt by the high temperature solder.Stimulation to eyes and respiratory system can be made by Smoke produced by welding process.
眼睛For Eyes 可能会对眼睛有暂时的轻微刺激性。Slight irritation may occur temporarily to eyes.
考研政治参考书食入Ingestion 通常认为是无毒的。大量食入可能会引起胃肠紊乱。
It is generally regarded as non-toxic.Gastrointestinal dysfunction will be caud with a great amount of ingestion.
营销小故事吸入Inhalation 使用过程中助焊剂所产生的烟雾可能影响黏膜及呼吸系统。
Smoke produced by the flux may affects mucous membranes and respiratory system.
frustrate的形容词
皮肤吸收Skin absorption 不大可能。Less likely to occur.
潜在的健康效应（长期接触）：不适用。
Potential health effects(Long-term contact):Not suitable.
四、急救措施Emergence Treatments
眼睛For Eyes 烫伤眼睛时请用大量清水冲洗并及时就医。
Eye burnt,plea wash them with plenty of water and go to e a doctor immediately.
皮肤For Skin 皮肤灼伤马上用凉水冲洗。
Skin burnt,plea wash it with cold water at once.
吸入Ingestion 呼吸新鲜空气。不能呼吸时给予人工呼吸。呼吸困难时供氧辅助呼吸。Breathe in the fresh air.Artificial respiration should be given when there is any breathing,and oxygen should be supplied when breathe difficultly.
食入Inhalation 如被吞食，寻求医疗协助。除非在医务人员的指导下，否则不可催吐。
If swallowed,plea ask for medical assist.Emetic must be taken with guidance of medical staff.
医生注意事项：无特别解毒剂。应给予看护。医生需根据病人的反应作出判断，给予治疗。
Notes to doctors：No special antidote.Nursing should be given.Treatments should be given on the basic of patients’reaction.
五、防火措施Fire Precaution
可燃性combustibility □可燃combustible
■不可燃non-conbustible
应避免条件
Conditions avoided
无。
None.
闪点不详。自燃温度不详。
Flash point Unknown.Autoignition temperature Unknown.
燃烧极限Combustion Limits 不详。
Unknown.
灭火介质
Extinguishing media
□水W ater
□二氧化碳CO2
□泡沫Foam
■灭火干粉Fire fighting powder
危险的燃烧产物
Hazardous combustion products 金属粉尘、蒸气
Metal dust,vapor
常态分解
Normal Decomposition
□可分解decomposable
■不可分解indecomposable
爆炸的可能性The possibility of explosion 加热、冲击、火花、明火条件下一般不会产生爆炸。
Explosion will not happen with the conditions of heat、impact、spark and open fire.
灭火指示Instructions of fire-extinguishing 无。None.
六、意外泄漏防护措施Protective measures of accidental leak
个人防护Personal Protection 避免和皮肤、眼睛接触，彻底通风，不可呼吸蒸气，杜绝明火，隔离火源，禁止吸烟，避免产生火花，撤离非有关人员，无人身危险时，关闭泄漏。
Avoid the contacts with skin and eyes,ventilate the area thoroughly,do not breathe in vapor, stop the open fire,isolate the source of fire,no smoking,avoid the spark producing, withdraw the irrelevant person,shut off the leak with no personal risk.
环境防范Environmental precaution 防止污染土壤和水，用砂，土防止扩散或进入下水沟，江河。
To prevent the contamination of soil and water,the diffusion and permeation of gutter and river with sand and soil.
熔融焊料Molten solder 待其冷却至室温，再加以回收利用。回收过程注意避免吸入烟雾。
Recycling when its cool to indoor temperature,plea avoid smoke-breathing during the recycling progress.
七、使用和储存U and Storage
使用U 焊料加热时避免吸入金属蒸气。焊料切割和打磨操作时避免吸入灰尘。产品使用时应穿戴防护用品避免与眼睛、皮肤及衣服接触，以防烧烫伤。保持使用环境的良好通风。
Avoid breathing vapor produced by solder heating of metal.Avoid dust Avoid breathing the dust while the cutting and polishing of solder is on.Protective equipment should be dresd to prevent to be out of burn and scald without the contact with eyes,skin and clothes directly.Keep well-ventilated at workplace.
储存Storage 注意通风。置于干燥处。与酸性介质接触或储存环境湿度过高将使焊料表面失去金属光泽。
Pay attention to ventilation,put in a dry place,the surface of solder will lo metallic luster with the contact of acidic medium and high environmental humidity storage.
储存温度Storage Temperature 0~40℃，相对湿度85%RH以下。
0~40℃，relatively humidity<=85%RH.
产品转移Production transfer 无。
None.法拉古特国际学校学费
器材
Equipment
无。
None.
八、接触控制与个人保护Contact Control and Personal Protection
工程控制Engineering Control 在大多数情况下，提供良好的抽风即可。控制室内的温度和干燥度达到要求。Good ventilation is necessary in most instances.Temperature and dryness in the room should meet the requirements.
个人保护措施Personal protective measures
呼吸系统保护Respiratory protection 通风不好时，配戴全面罩呼吸器。
Wear full-face respirator when it comes to ill ventilation.
god be with you手保护Hands protection 胶手套或布手套。Rubber or fabric gloves.
米勒斯眼睛保护Eyes protection 安全防护眼镜。Safety glass.
身体保护Body protection 工作服。
Overalls,chemical resistant safety shoes.
个人卫生习惯Personal hygienic habits 操作化学物品或含铅焊料以后应彻底洗手。
Wash hands thoroughly after operating chemicals or leaded solder.
九、物理与化学性质Physical and Chemical Properties
外观（20℃）Appearance 固体
solid
比重（水=1at25℃）
Proportion(water=1at25℃)
7.31g/cm3
熔点（℃）Melting Point 227℃
沸点（760mm Hg)
Boiling point
不适用。
Inapplicable.
蒸发压（mm Hg at20℃) Vapor Pressure 无建立。
Unfounded.
挥发速度
Volatile speed
0%
蒸发密度（air=1) Evaporation density 不适用。
Inapplicable.
挥发体积百比分
V olatile Volume Percentage
0%
水中溶解度Solubility in the water 0
挥发性有机物
Volatile Organic Compound
不适用。
Inapplicable.
PH 不适用。
Inapplicable.
气味
Smell
无建立。
unfounded.
凝固点（760mm Hg) Condensation point，不适用。
unluckyInapplicable.
W/O分布系数
distribution coefficient
无建立。
unfounded.
颜色及气味Color and Smell 银白色，无味。Silvery,tasteless.
十、稳定性/反应性Stability and Reactivity
化学稳定性Chemical stability 在一般温度下稳定。
longxueStable under the general temperature.
应避免情况Condition avoided 热、火焰、潮湿、浸水。heat,fire,wet,water.
与其它材料不相容性Incompatible materials 强酸、强氧化性介质。Strong acid and oxidizing medium.
有毒的分解产物Toxic decomposition product 不适用。Inapplicable.
腐蚀性Corrosivity 无。None.
十一、毒性数据Data of Toxicity
急性口服毒性Acute oral toxicity 低毒性，LD50﹥2000mg/kg。Low toxicity,LD50﹥2000mg/kg.
急性皮肤毒性Acute skin toxicity 低毒性，LD50﹥2000mg/kg。Low toxicity，LD50﹥2000mg/kg.
急性吸入毒性Acute inhalation toxicity 低毒性，LD50﹥5mg/L。Low toxicity，LD50﹥5mg/L.
