自动落锁功能的调出 英文版及翻译
(适用于欧洲福特、台湾六合福特、重庆长安福特所有C1平台车型)
简单地翻译了一下，供大家参考
The enable/disable mode is entered when the following ries of steps is performed.考研科目分数
Install Time: Difficulty Level:
5 Minutes 1
Directions:
Step 1
Confirm that the perimeter alarm is disarmed.回顾与展望
确认车辆安全停放
Step 2
Clo all doors.
关闭所有车门
Step 3
采菱歌曲Confirm that the ignition switch is in the OFF position.
Note: Steps 4 through 8 must be performed within 30 conds.
确认车辆点火开关处于关闭状态
注意：第四步骤到第八步骤必须在30秒内完成
Step 4
Turn the ignition switch from OFF to RUN.
将点火开关从关闭到打开状态（开关从I到II状态，不要着车）
Step 5
Press the power door lock UNLOCK button three times.
将车门锁从开到关连续按动3次（关-开-关-开-关-开）
Step 6
Turn the ignition switch from RUN to OFF.
蔡志文
将车辆点火开关从打开到关闭状态（从II到I）
Step 7
Press the power door lock UNLOCK button three times.
将车门锁从开到关连续按动3次（关-开-关-开-关-开）
Step 8
Turn the ignition switch from OFF to RUN.
将车辆点火开关从关闭到打开状态（从I到II）元宵节的由来20字
Step 9
Verify that the RAP module chirps the horn. This indicates that the RAP module is now in the enable/disable mode and ready to accept program changes.
这时行车电脑会发出短鸣声，说明行车电脑模块已经进入可编辑状态。
天宫加点Step 10
Press the power door lock UNLOCK button one time to command the RAP module to toggle the autolock/relock feature ON or OFF.
将车门锁从关到开一次（关-开），以触发行车电脑模块的自动锁生效或取消。
Step 11
Press the power door lock LOCK button once to enter the command.
将车门锁从关到开一次（关-开），（RAP）执行指令。
Step 12
Verify that the vehicle horn chirps one time to signal the RAP module confirmation of the command. There should only be one chirp indicating that the autolock/relock feature has been disabled. If one chirp is heard, followed by a longer honk, the autolock/relock feature has just been enabled. Return to step 10.
这时会听到一声短鸣声，说明行车电脑模块指令已经执行。如果听到一声短鸣声，说明自动锁功能被取消，如果听到一声长鸣声，说明自动锁功能启动。重新执行第十步骤。
Step 13
Turn the ignition switch to the OFF position to exit the enable/disable mode.
将车辆点火开关转到关闭状态，退出编辑模式。
删除文件命令Step 14
Verify that the RAP module chirps the horn once to indicate that a feature has been changed.晋江耽美小说
会再听到一声短鸣声，表示设置成功。
