30 Watts
Description
The BLP30 Series’ economical and compact construction provides single or three-output AC to DC power conversion to meet the requirements of most commercial and industrial applications.
Single-Output Model Selection
Model Nominal Output Voltage (VDC)
Min-Max Output
Current (Amps),
Convection Min-Max Output Current (Amps),
Forced Air 1
Peak Output
Current (Amps) 2 Total
Regulation
(%) 3
Ripple & Noi
pk-pk % 4
BLP30-1005G 5V 0 – 5 0 – 6 7.2 ± 2 1 BLP30-1012G 12V 0 – 2.1 0 – 2.5 3.0 ± 2 1 BLP30-1024G
24V
0 – 1.0
0 – 1.25
1.5
± 2
0.6
Triple-Output Model Selection
Model Nominal Output Voltage (VDC)
Min-Max Output
Current (Amps),
Convection Min-Max Output Current (Amps),Forced Air 1
Peak Output
Current
(Amps) 2
Total
Regulation (%) 3
Ripple & Noi
pk-pk % 4
+5V 0.2 – 2.5 0.2 – 3.5 5 ±2 1% BLP30-3000G
+12V 0.1 – 1.2 0.1 – 2.0 3 ±5 1%
-12V
0.0 – 0.3
0.0 – 0.5
1
±5
1%
1
10 CFM or 260 LFM (average measurement of six equally-distributed points through a 3.5" x 1.6" (9 cm x 4 cm) cross-ctional area with power supply mounted on a 0.25" (6.35 mm) standoffs. Recommended airflow direction is from the AC input to the DC output. 2
Peak current duration for less than 30 conds with a max duty cycle of 10%. 3
At 25 °C ambient including voltage t point tolerance, line, and load regulation 4
Maximum peak-to-peak noi expresd as a percentage of output voltage, 20 MHz bandwidth, measured with a twisted pair differentially across a 10 µF E-cap and a 0.1 µF ceramic cap in parallel. The point of measurement is within 1 cm of the output connection.
Applications • Datacom (hubs, routers) • POS terminals • Industrial
• Cable modems
• External disk storage • Medical instrumentation • Computers
Features • RoHS compliant for all six substances • 2” x 4” footprint
• Component height less than 1”
巨蟹座的特点• 25 W rating with natural convection cooling • 30 W rating with 10 CFM airflow • Compliance to EMI Class B • Universal AC input • Short-circuit protection • Overvoltage protection
• CE marked to Low Voltage Directive (Pending) • Compliance to EN61000-4-2/-3/-4/-5/-6/-8/-11 •
Two-year warranty
30 Watts
ELECTRICAL SPECIFICATIONS
Input Specifications
Parameter Conditions/Description Min.
Nom.
Max.
Units Input Voltage - AC Single-pha continuous input range 90 100 - 250 264 VAC
Input Voltage - DC 127 160/325 375 VDC
Input Frequency AC Input 47 50 - 60 63 Hz
Input Current At 90 VAC input., 30W 0.75 A rms
Inrush Surge Current Internally limited. 115 VAC, Max Power, 25 °C
Internally limited. 230 VAC, Max Power, 25 °C 16
32
A pk
A pk
Input fu Non-ur rviceable internally located AC
input line fu is provided.
Efficiency At maximum output power. 70 75 %
Switching Frequency 60 69 kHz
Output Specifications
Parameter Conditions/Description Min.
Nom.
Max.
Units
Output power With convection cooling. See Model Selection.
With forced-air cooling. See Model Selection. 25 30
Watts
Load transient Vo1, Vo2, or Vo3 deviation due to a 50 to 100%
load change at a rate of 1A/µs.
±5 %
Turn on Delay Time required for outputs to be within regulation
after initial application of AC input.
1.5Sec
Ri Time Time required for output voltage to ri from
赵尚志简介10% to 90%. 20
ms
Hold-up Time At 30W, 115 VAC, 60 Hz. 20 Ms
Overvoltage Protection Main output. 5V:
12V:
24V:
5.6
14.0
29.0
6.9
16.7
34.2
V
Short-circuit Protection Fully-protected against output short circuit.
Overshoot Single-output
models. 2
% Overshoot Triple-output
models. 5
%
最字笔顺30 Watts
Regulatory & Safety Approvals
Parameter Conditions/Description Min.
Nom.
Max.
Units UL60950-1 All models are approved.
CSA-C22.2,
No. 60950-1-03
All models are approved.
EN 60950-1
/IEC 60950-1
All models are approved.
CE Mark for LVD All models are approved.
CB
Approval Completed.
Ground Continuity At 12 VDC. 30 A
教学总结
Dielectric Withstand Voltage Input-to-Ground (Basic)
.
Input-to-Output (Reinforced). The primary to
condary test is not performed on completed
asmblies.
Output-to-Ground (Functional).
2121
4242
500
VDC
VDC
VDC
Electromagnetic Interference FCC Part 15. Conducted:
CISPR 22 and CISPR 11. Conducted:
B
B
Class
ESD Per EN 61000-4-2, level 2.
Radiated Susceptibility Per EN 61000-4-3, level 3. 3 V/m EFT/Burst Per EN 61000-4-4, level 3. 1 kV
Input Transient Protection Per EN 61000-4-5, class 3. Line-to-Line:
Line-to-Ground:
1
2
kV
RF Immunity Per EN 61000-4-6, level 3. 3 V/m Magnetic Fields Per EN 61000-4-8. 1 A/m Voltage Interruptions Per EN 61000-4-11
Leakage Current Per EN 60950 At 115 VAC:
At 230 VAC: 0.2 0.4
mA
30 Watts
Environmental Specifications
Parameter Conditions/Description Min.
Nom.
Max.
Units
Altitude Operating.
Non-Operating. 10K 50K
ASL ft
ASL ft
Operating Temp 0 ºC to 70 ºC with linear derating to 50% above
50 ºC. Unit will start-up at -20 ºC, but will not
meet all published specifications.
0 50 70ºC Storage Temp -40 85 ºC
Temperature Coefficient 0 ºC to 70 ºC (after 15-minute warm-up). ±0.02 %/
ºC
Relative Humidity 95% relative humidity @ 40 ºC, non-condensing 95 %RH
Shock Operating: half-sine, 11 ±3 ms, 3-axis.
Non-Operating: half-sine, 11 ±3 ms, 3-axis. 15 40
G
试用期辞退
G
Vibration Operating: Random vibration; 5 to 500 Hz
(10 minutes, each axis).
Non-Operating: Random vibration; 5 to 500 Hz
(10 minutes, each axis). 2.4 6
Grms
Grms
30 Watts
Mechanical Drawing – Single Output Models All dimensions are in inches.
RECOMMENDED MATING CONNECTORS *
HOUSING PIN
CN1 and CN2 MOLEX 22-01-2051 MOLEX 08-52-0123
MOLEX 22-01-2057 MOLEX 08-52-0101 MOLEX 22-01-3057 LEOCO 2530S05000 LEOCO 2533TPB0000 *
Equivalent housings and pins can also be ud.
4.00 +/- 022.07+/-.021.07+/-.020.91
0.1
0.06
3.750
1.750Ø 0.16 (4 places)
Printed Circuit Board
fastener
clearance area 0.25 DIA (4places)
CN1 input connector
CN2 - DC output connector (e pin-out table)
Pin 1VOUT Pin 2DC COM Pin 3VOUT Pin 4DC COM Pin 5
VOUT
TOP VIEW
SIDE VIEW
END VIEW
CN2 - DC CON Pin 1AC Neutral Pin 3AC Line Pin 5
AC Ground
CN1 - AC CONN.Pin #1
Pin #1
PCB AC Ground Connection
Point - Solder side
30 Watts
Mechanical Drawing – Triple Output Model All dimensions are in inches.
RECOMMENDED MATING CONNECTORS *洁银牙膏
HOUSING PIN
CN1 and CN2 MOLEX 22-01-2051 MOLEX 08-52-0123
MOLEX 22-01-2057 MOLEX 08-52-0101 MOLEX 22-01-3057 LEOCO 2530S05000 LEOCO 2533TPB0000 *
Equivalent housings and pins can also be ud.
NUCLEAR AND MEDICAL APPLICATIONS - Power-One products are not designed, intended for u in, or authorized for u as critical components in life support systems, equipment ud in hazardous environments, or nuclear control systems without the express written connt of the respective divisional president of Power-One, Inc.
TECHNICAL REVISIONS - The appearance of products, including safety agency certifications pictured on labels, may change depending on the date manufactured. Specifications are subject to change without notice.失去的英文
4.00 +/- 022.00+/-.021.07+/-.020.91
0.1
0.06
3.750
1.750Ø 0.16 (4 places)
Printed Circuit Board
fastener
clearance area 0.25 DIA (4places)
CN1 input connector
CN2 - DC output connector (e pin-out table)
Pin 1Vo3
排列数公式
Pin 2DC Com Pin 3Vo1
Pin 4DC COM Pin 5
Vo2
TOP VIEW
SIDE VIEW
END VIEW
CN2 - DC CON Pin 1AC Neutral Pin 3AC Line Pin 5
AC Ground
CN1 - AC CONN.Pin #1
Pin #1
PCB AC Ground Connection
Point - Solder side