本规格书适用于没有键面的按键开关.
宜兴张公洞风景区This specification applies to push switches which have no keytop. 1-2.标准状态Standard atmospheric conditions 除另有规定外,测量应在以下状态下进行:
Unless otherwi specified ,the standard range of atmospheric conditions for making measurements and test is as following limits:PS08522NY SERIES SPECIFICATION
1.一般事项 General specification
1-1.适用规格 Scope
温 度 Ambient temperature : 20±2℃
相对湿度 Relative humidity : 60% to 70% 气 压 Air pressure :86kpa to 106kpa 1-3.使用温度范围
Operating temperature range :-40℃~+85℃ (normal humidity,normal air pressure 正常湿度,正常气压) 1-4.保存温度范围
温 度 Ambient temperature :5℃ to 35℃ 相对湿度 Relative humidity : 45% to 85% 气 压 Air pressure :86kpa to 106kpa
如果对在上述所提到的条件中所做的实测值有疑问的话,应使用以下条件进行测量:
If doubt aris on the decision bad on the measured values under the above-mentioned conditions,the following conditions shall be employed: Storage temperature range :-40℃~+85℃ (normal humidity,normal air pressure 正常湿度,正常气压)
2.构造 Construction
4.动作型式 Type of actuation
4-1.有触感之回馈 Tactile feedback
5.接点构成 Contact arrangement
5-1.2P2T(见所附成品图)2 poles 2 throws(Refer to attached drawing)
6.最大额定 Maximum ratings
火山地热
6-1. DC 30V,0.1A OR DC 13V,1A
2-1.尺寸 Dimensions
见所附成品图 Refer to attached drawing
杀手锏乐队3.外观 Appearance
3-1.不得有影响制品机能之缺陷 There shall be no defects that affect the rviceability of the product
7-1.接触阻抗Contact resistance
开关内各接触部位之间,用1KHZ低电阻测试仪测量.
50m Ω以下Among the contacting part of switches,with 1 kHz small-current contact resistance meter.
50m Ω Max
7.电气性能 Electrical Characteristics
项目条件规格
ITEM
鞭炮作文CONDITIONS
SPECIFICATIONS
7-3.耐电压
Dielectric withstand 以AC 500V(50∼60Hz)之电压加于端子相互之间以及端子与外框之间1分钟。不得有绝缘破坏
AC 500V (5060Hz) shall be applied across terminals
Without arcing or breakdown
付出就有回报
亭字组词7-2.绝缘阻抗
Insulation resistance 在端子相互之间以及端子与外框之间施加电压DC 500V 1分钟
风干鱼。
100M Ω 以上
Measurements shall be made following application of DC 500V potential across terminals and across Terminals
and frame for one minute。100M Ω Min in voltage
and across terminals and frame for one minute。g
鹅乸饭