ccie350-001题库翻译满分的

更新时间:2023-07-28 01:43:09 阅读: 评论:0

ccie350-001题库翻译满分的
衣服的英文单词1.What is the purpo of an explicit "deny any" statement at the end of an ACL?
什么是明确表达在一个ACL最后有一个拒绝所有的条目下奶的食物有哪些
D. to allow the log option to be ud to log any matches
用它来匹配剩下所有的项目
2.Which of the is mandatory when configuring Cisco IOS Firewall?
那个被强制配置在CISCO的防火墙上
E. an inbound extended ACL applied to the untrusted interface
一个在in方向上的扩展ACL 应用在不可信的端口上
3. Which statement correctly describes the disabling of IP TTL propagation in an MPLS network?
哪种说法正确地描述了MPLS网络中IP传输的TTL是禁用的?
D. The TTL field of the MPLS label header is t to 255.
TTL失效是因为MPLS的标签头的TTL字段设置为255。
4. Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correct BGP ssion endpoint address and the correct BGP ssion hop-count limit (EBGP multihop). What is a good first test to e if BGP will work across the firewall?
有两个运行BGP的路由器连接到防火墙,一个在inside接口,一个在outside 接口。BGP 已经配置并且已经成为了邻居,包含正确的配置了BGP网络地址和正确的BGP跳数的限制(EBGP的多跳设置),怎么能够最好的测试BGP工作在防火墙上。
A. Attempt to TELNET from the router connected to the inside of the firewall to the router connected to the outside of the firewall. If telnet works, BGP will work, since telnet and B
GP both u TCP to transport data.
一亩地多少个平方
用在inside接口上的路由器telnet 到在outside 接口上的路由器。如果telnet 正常工作侧说明BGP能正常工作,因为telnet 和BGP 都是使用TCP 来传输数据的
5. Spanning Tree Protocol IEEE 802.1s defines the ability to deploy which of the?
哪个是生成树协议802.1s的定义。?
C. one STP instance per t of VLANs
一组VLAN使用同一个STP 实例
6. Which two of the are ud in the lection of a root bridge in a network utilizing Spanning Tree Protocol IEEE 802.1D? (Choo two.)
在生成树协议802.1D中,选择根桥需要用到那两个参数?
B. bridge ID priority
网桥的优先级
D. bridge ID MAC address
网桥的MAC地址
7. If a port configured with STP loop guard stops receiving BPDUs, the port will be put into
which state?
在STP中一个接口停止接收BPDU信息了,那么这个接口是什么状态?
D. root-inconsistent state
根状态发生了改变
航母多大
8. What is the purpo of the STP PortFast BPDU guard feature?
什么是生成树开启PortFast BPDU保护功能的目的
C. enforce the borders of an STP domain
配置了生成树域的边界
萦的读音9. When STP UplinkFast is enabled on a switch utilizing the default bridge priority, what will the new bridge priority be changed to?怎样养猪长得快
当STP的uplink Fast端口上使用了一个默认优先级的交换机,这个交换机的优先级将变成什么?
C. 49152
49152
10. Which of the best describes the actions taken when a VTP message is received on
a switch configured with the VTP mode "transparent"?
那一项最能说明,收到的VTP信息是从透明模式的交换机收到的?
B. VTP updates are ignored and forwarded out trunks only.
VTP忽略更新,只是做了转发。
11. Refer to the exhibit. In this network, R1 has been configured to adverti a summary route,192.168.0.0/22, to R2. R2 has been configured to adverti a summary route, 192.168.0.0/21, to R1. Both routers have been configured to remove the discard route (the route to null created when a summary route is configured) by tting the dministrative distance of the discard route to 255. What will happen if R1 receives a packet destined to 192.168.3.1?
如图所示,在这个网络中,R1通告了192.168.0.0/22的汇总路由给R2,R2通告了192.168.0.0/21的汇总路由给R1。两台路由器都配置了汇总路由的null0接口来防止路由的环路。发生什么情况,R1能收到一个去192.168.3.1的数据包?
A. The packet will loop between R1 and R2.
这个包在R1和R2之间形成了环路
12. Refer to the exhibit. In this network, R1 is configured not to perform
auto-summarization within EIGRP.What routes will R3 learn from R2 through EIGRP?
如图所示,在这个网络中R1配置为在EIGRP中不做自动汇总,那么R3能从R2学到什么EIGRP 的路由信息。
A. 172.30.1.0/24 and 10.1.2.0/24; EIGRP only performs auto-summarization at the edge between two major networks.
172.30.1.0/24 和10.1.2.0/24 EIGRP在两个较大的网络边缘只能执行自动汇总。
13. The classic Spanning Tree Protocol (802.1D 1998) us which quence of variables to determine the best received BPDU?
基本的生成树协议(802.1D),使用哪些参数来确定最佳的BPDU的包
D. 1) lowest root bridge id, 2) lowest root path cost, 3) lowest nder bridge id, 4) lowest nder port id
老年心理学1 最低的根桥ID 2最小的到根桥的路径3最小的PBDU的发送者的ID 4最小的PBDU的发送者接口。
14. Which three port states are ud by RSTP 802.1w? (Choo three.)
哪三个状态出现在RSTP 802.1W中
B. Learning
学习
跳绳运动C. Forwarding
装法
E. Discarding
阻塞
15. Refer to the exhibit. Catalyst R is the root bridge for both VLAN 1 and VLAN 2. What is the easiest way to load-share traffic across both trunks and maintain redundancy in ca a link fails, without using any type of EtherChannel link-bundling?
如图所示,在这个网络中交换机R是vlan 1 和vlan 2 的根桥。在一条线路故障的时候用什么最简单的办法来使通过trunk的流量有沉余,不能使用任何的EtherChannel。
B. Decrea the port priority on R2 for VLAN 2 on Catalyst R so that port D1 will be blocked for VLAN 2 and port D2 will remain blocked for VLAN 1.
在交换机R上减少VLAN2的优先级,使得端口D1阻塞VLAN2 ,端口D2阻塞VLAN1
16. Refer to the exhibit. In the diagram, the switches are running IEEE 802.1s MST. Which ports are in the MST blocking state?

本文发布于:2023-07-28 01:43:09,感谢您对本站的认可!

本文链接:https://www.wtabcd.cn/fanwen/fan/89/1099396.html

版权声明:本站内容均来自互联网,仅供演示用,请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系,我们将在24小时内删除。

标签:配置   使用   交换机   生成   接口
相关文章
留言与评论(共有 0 条评论)
   
验证码:
推荐文章
排行榜
Copyright ©2019-2022 Comsenz Inc.Powered by © 专利检索| 网站地图