Korepox Zinc Rich Primer EZ175C (Two-Component)双组份环氧富锌底漆
Product Description 产品描述
A two component,polyamide cure bad epoxy zinc primer with high content of total zinc.
It provides long term protection of steel in verely corrosive environment,and has outstanding resistance to mechanical tear and wear.Approved as a Prefabrication Primer by Lloyd’s Register of Shipping (LR).Approved as an Excellent Primer for the Container by Constant Laboratories Inc.It can b
e ud for fresh water tank with suitable topcoat in accordance with FDA Regulations,ction 175.300.
EZ175C 是一种双组份、聚酰胺固化、富含金属锌环氧底漆，它为严重腐蚀性环境中的钢材提供长效保护并有优异的耐机械磨损性能。作为一种极好的集装箱用底漆已通过英国劳氏船级社（LR ）和Constant Laboratories Inc 的认可。按照美国食品和药物管理局规范175.300章节规范，它可用于淡水舱并复涂合适的面漆。
Recommended U 推荐用途
As a long-life primer for u on steel subjected to corrosive environment and mechanical hard wear.As a shop-primer for corrosion protection from blast cleaned surface.作为腐蚀性环境中和经受机械磨损钢材的长效保护底漆。作为从喷砂到最后面漆用于防腐保护的车间底漆。
Physical Properties 物理特性
Finish and Color 外观及颜色Flat.Metallic Grey (1184)无光，金属灰色（1184）Drying Time 干燥时间
Substrate temperature 底材温度5℃/41℉20℃/68℉30℃/86℉
Set to touch 指触干50min 20min 10min Dry through 硬干
18h
4h
3h
*The actual drying time is subject to the film thickness,ventilation,humidity etc.,and drying time under other temperature conditions should be checked and informed by KCC.
*实际干燥时间随着涂膜厚度，环境通风程度和湿度而不同，其他温度条件下的干燥时间请咨询KCC
Solids by Volume 固体含量体积比Approx.50%(Determined by ISO 3233)约50%（按ISO 3233测定）
Theoretical Spreading Rate 理论涂布率12.0㎡/L in 40dry film thickness on a smooth surface.
在光滑的表面上，干膜厚度40，则理论涂布率为12.0㎡/L 。Specific Gravity 比重Approx.2.4for Mixture of Ba and Curing agent.约2.40(主剂和固化剂的混合物)Flash Point 闪点
Ba (EZ175C PTA):15℃/59℉(Clod cup)
Curing Agent (EZ175PTB):26℃/79℉(Clod cup)主剂(EZ175C PTA):15℃/59℉(密闭杯)固化剂(EZ1
75PTB):
26℃/79℉(密闭杯)
Application Details 涂装指南
Surface Preparation 表面处理
Remove any oil,grea,dirt and any other contaminants from the surface before painting by proper method such as solvent cleaning and fresh water washing,etc.
*Steel :Blast cleaning to Sa 2.5or Power tool cleaning to St3,etc.清除待涂装表面所有油，脂和其它污染物。
*钢板：喷砂除锈至Sa2.5或用其它电动工具清理至St3。
Disclaimer :The information in this data sheet is believed to the best of our knowledge bad on laboratory test and practical experience.However,there are many factors affecting the performance of product and the product quality itlf,so we are not able to guarantee without the confirmation of the purpo of using the product from us in writing.We rerve the right to change the data without notice and you should check that this data sheet is current prior to using the product.
此技术资料根据实验与经验得出，可确保其准确性，但由于产品特性及影响产品品质的诸多因子，没有经过本公司确认而任意更换产品使用用途而发生的一切后果，本公司不负任何责任。在使用本产品之前，应确认产品技术资料是否为最新版本。
人人弹起Korepox Zinc Rich Primer EZ175C (Two-Component)双组份环氧富锌底漆
电影建军大业Application Conditions 施工条件
The surface should be completely cleaned and dried.Do not apply when relative humidity is above 8
5%.The surface temperature should be at least 2.7℃(5℉)above dew point to prevent condensation.In confined areas,ventilate with clean air during application to assist solvent evaporation.
涂装表面应干净而干燥；相对湿度不能超过85%，表面温度至少高于露点2.7℃(5℉)时才可施工，并使用空气枪帮助挥发有机物.
Mixing 混合
Ba (EZ175C PTA):Curing Agent (EZ175PTB)=25:2(by weight)
Mix thoroughly together prior to application in the proportions with power agitator as delivered.主剂：固化剂=25:2（重量比）
施工前各组份单独搅拌，然后按所述比例兑在一起并彻底混合。Pot Life 适用期8h at 20℃/68℉
在20℃/68℉，8小时。
u盘被写保护Thinning 稀释
中国有几大战区
Thinner No.053
*For airless spray application,it is designed to u parately according to asons as follows.Thinner No.053for spring and fall,Thinner No.053S for summer,Thinner No.053W for winter,
Thinner No.053BS for shopprimer.稀释剂No.053
*对于无气喷涂，稀释剂要根据季节如下选定。稀释剂No.053（春天和秋天）稀释剂No.053S （夏天）稀释剂No.053W （冬天）
惜别诗稀释剂No.053BS （车间锌粉底漆）
Application Method 涂装方法
Spray (Airless or Air),Roller or Brush application.For airless spray application ;Nozzle orifice :432(0.017″)Output pressure :17.2MPa Fan :30º~90ºThinning :Max.25%(up to 50%when shop-priming)(Airless spray data are indicative and subject to adjustment)
During the application,continuous agitation is required to prevent the dimentation of zinc powder.For brush application :U only for small areas or touch-up coating.刷涂、辊涂或喷涂（有气或无气）施工无气式喷涂
喷嘴直径:432(0.017″)喷口压力:17.2M P a 喷射扇面:30º~90º
（无气式喷涂的有关数据可根据指导进行调整）
在施工期间，要及时使用油漆，刷涂仅限于小面积修补。
Typical
Film Thickness 漆膜厚度
Shopprimer :10~20dry.Long-life primer :35~75dry.
May be specified in another film thickness than indicated depending on purpo and area of u.车间底漆：干膜10~20㎛长效型底漆：干膜35~75㎛
理论干膜厚度根据使用用途及部位而相异。
Disclaimer :The information in this data sheet is believed to the best of our knowledge bad on laboratory test and practical experience.However,there are many factors affecting the performance of product and the product quality itlf,so we are not able to guarantee without the confirmation of the purpo of using the product from us in writing.We rerve the right to change the data without notice and you should check that this data sheet is current prior to using the product.
此技术资料根据实验与经验得出，可确保其准确性，但由于产品特性及影响产品品质的诸多因子，没有经过本公司确认而任意更换产品使用用途而发生的一切后果，本公司不负任何责任。在使用本产品之前，应确认产品技术资料是否为最新版本。
Korepox Zinc Rich Primer EZ175C (Two-Component)双组份环氧富锌底漆
Recoating Interval 重涂间隔
At 20℃/68℉,
Minimum :4h (for main primer)
Maximum :According to specification.
Prior to overcoating,remove the oil,salt,chalking material and any other contaminants on aged coating film completely by proper cleaning method such as solvent cleaning and/or fresh water washing.
在20℃/68℉，最短:4小时（作为主要底漆）
最长：根据配套暴露于不洁环境后，在下一涂层之前，应用合适的清洁方法，如高压淡水冲洗、溶剂清洗等方
独生子女证明模板法彻底清洁表面，待表面干燥后再涂装。Subquent Coat 后续喷漆According to specification.根据配套Shelf Life 有效期12months 12个月Heat Resistance 耐热性能
Continuous :93℃/200℉(Non-immersion rvice)Non-continuous :121℃/250℉(Non-immersion rvice)连续性:93℃/200℉(非沉浸式服务)间断式
节约用水演讲稿
:121℃/250℉(非沉浸式服务)
Chemical Resistance 耐化学性能
Acids
酸
Alkalis 碱Solvents 溶剂Salts 盐Water 水Splash &Spillage 溅液Fair 一般Fair 一般Good 好Excellent 极好Excellent 极好Fumes 烟雾
Good 好
Good 好
Excellent 极好
Excellent 极好
Excellent 极好
Standard Packing
Unit
包装规格27KG (EZ175C PTA :25KG,EZ175PTB :2KG)27公斤(EZ175C PTA :25公斤,EZ175PTB :2公斤)
Remarks 备注
Do not store at temperature below 5℃/41℉or above 40℃/104℉.
Protect skin and eyes from direct contact with liquid paint,and avoid prolonged breathing of solvent vapors.
关于爱国的电影
U with adequate ventilation.
Respiratory protection is recommended when applying this product in confined spaces or stagnant air.不要储存在温度低于5℃/41℉或高于40℃/104℉的地方。注意保护皮肤和眼睛，避免长时间吸入挥发的溶剂。通风要充分。
在密闭空间或空气不流通场所使用本产品，建议使用呼吸保护装置。
Issued 发布于April 20082008年4月
Disclaimer :The information in this data sheet is believed to the best of our knowledge bad on laboratory test and practical experience.However,there are many factors affecting the performance of product and the product quality itlf,so we are not able to guarantee without the confirmation of the purpo of using the product from us in writing.We rerve the right to change the data without notice and you should check that this data sheet is current prior to using the product.
此技术资料根据实验与经验得出，可确保其准确性，但由于产品特性及影响产品品质的诸多因子，没有经过本公司确认而任意更换产品使用用途而发生的一切后果，本公司不负任何责任。在使用本产品之前，应确认产品技术资料是否为最新版本。
