Reference number ISO 9117-1:2009(E)
INTERNATIONAL STANDARD ISO 9117-1
First edition 2009-05-15
Paints and varnishes — Drying tests — Part 1:
Determination of through-dry state and through-dry time
Peintures et vernis — Essais de séchage —
Partie 1: Détermination du séchage à cœur et du temps de séchage à cœur
--`,,`,,``,```,,`,``,,````,,,``,-`-`,,`,,`,`,,`---
ISO 9117-1:2009(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licend to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products ud to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for u by ISO member bodies. In the unlikely event that a problem relating to it is found, plea inform the Central Secretariat at the address given below.
COPYRIGHT PROTECTED DOCUMENT
© ISO 2009
All rights rerved. Unless otherwi specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office
Ca postale 56 • CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso Web www.iso Published in Switzerland
--`,,`,,``,```,,`,``,,````,,,``,-`-`,,`,,`,`,,`---
ISO 9117-1:2009(E)
Contents Page
Foreword (iv)
1Scope (1)
2Normative references (1)
3Terms, definitions and abbreviated terms (1)
4Principle (2)
5Apparatus and materials (2)默默付出
6Sampling (4)
舞蹈的英文7Test panels (4)
7.1Substrate (4)
7.2Preparation and coating (4)
8Procedure (5)
8.1Preparation of apparatus (5)
8.2Drying the test panel (5)
8.3Determination of through-dry state (5)
8.4Determination of through-dry time (5)
8.5Thickness of coating (6)
9Precision (6)
10Test report (6)
塞翁失马文言文Bibliography (7)
--`,,`,,``,```,,`,``,,````,,,``,-`-`,,`,,`,`,,`---
ISO 9117-1:2009(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be reprented on that committee. Interna
tional organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates cloly with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 9117-1 was prepared by Technical Committee ISO/TC 35, Paints and varnishes, Subcommittee SC 9, General test methods for paints and varnishes, in collaboration with CEN/TC 139, Paints and varnishes.
It cancels and replaces ISO 9117:1990, which has been technically revid. The main changes are:
a) failure is defined in terms of damage, rather than damage or marking;
b) the former Annex A concerning required supplementary information has been integrated in the test report.
ISO 9117 consists of the following parts, under the general title Paints and varnishes — Drying tests:
关于父亲的名言⎯Part 1: Determination of through-dry state and through-dry time
⎯Part 2: Pressure test for stackability1)
⎯Part 3: Surface-drying test using ballotini2)
--`,,`,,``,```,,`,``,,````,,,``,-`-`,,`,,`,`,,`---
1) To be published. (Revision of ISO 4622:1992)
公园怎么画
2) To be published. (Revision of ISO 1517:1973)
INTERNATIONAL STANDARD ISO 9117-1:2009(E)
透明头像怎么弄Paints and varnishes — Drying tests —
Part 1:
Determination of through-dry state and through-dry time
1 Scope
This part of ISO 9117 specifies a test method for determining under standard conditions whether a single coat or a multi-coat system of paint, varnish or related material has reached the through-dry state after a specified drying period.
NOTE The test procedure may also be ud to determine the time taken to achieve that state.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 48, Rubber, vulcanized or thermoplastic — Determination of hardness (hardness between 10 IRHD and 100 IRHD)
ISO 1513, Paints and varnishes — Preparation of test samples
ISO 1514, Paints and varnishes — Standard panels for testing
ISO 2808, Paints and varnishes — Determination of film thickness
ISO 15528, Paints, varnishes and raw materials for paints and varnishes — Sampling
3 Terms, definitions and abbreviated terms
For the purpos of this document, the following terms, definitions and abbreviated terms apply.
男孩女孩教案3.1
IRHD scale
international rubber hardness degree scale
3.2
through-dry state
正确英语
condition of a film in which it is dry throughout its thickness
NOTE 1 The through-dry state should not be confud with the condition in which the surface of the film is dry but the bulk of the coating is still mobile.
--`,,`,,``,```,,`,``,,````,,,``,-`-`,,`,,`,`,,`---
