3M™ Pedestal Stand 749
This pedestal stand can be ud with 3M™ Wrist Strap Testers 740, 747 and 746. The 749 is made of stainless steel for durability and has a tip-over angle of greater than 45 degrees. Its unique top plate can support any of the 3M wrist strap testers, and it can accommodate certain models of barcode and magnetic readers.
Designed for u in manufacturing areas, this unit is lf-supporting, stand alone and portable. The ba plate is joined to the support column by stainless steel bolts and has insulated washers to keep the operator from bypassing the grounding wire and creating an electrical short. This feature helps guard against a fal reading by creating a cond path for the circuit.
Specifications
Weight9 lbs.
Asmbled Height40.5
Construction Stainless Steel
Includes: Stand pole, ba, hardware, ground wire and instructions.
浮沉2Asmbly instructions on rever side.
Important Notice
Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability associated with such u. Warranty; Limited Remedy; Limited Liability.
This product will be free from defects in material and manufacture at the time of purcha. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the warranty period stated above, your exclusive remedy shall be, at 3M’s option, to replace or repair the 3M product or refund the purcha price of the 3M product. Except where prohibited by law, 3M will not be liable for any indirect, special, incidental or conquential loss or damage arising from this 3M product, regardless of the legal theory asrted.
3
表面之下
3M Electronic Solutions Division
Static Control Products
926 JR Industrial Drive
Sanford NC 27332 (866)722-3736 (866)722-3735 fax /static Plea recycle. Printed in USA.© 3M 2008. All rights rerved.
78-9100-5030-7
Asmbly Instructions
Run grounding cable (ring terminal end) 1.
through top plate and through support
column. For 3M™ Wrist Strap Testers
740, u cable included in this kit. For
model 747, u the wire packaged with
that wrist strap tester.
Make sure that grounding cable is also 2.
placed through the isolation gasket.
Secure the ground cable ring terminal to 3.
品牌营销方案
the ba plate using the bolts provided
(fasten to center hole).
Install the isolation sleeves inside the 4.太史公自序
数学反思
pre-drilled holes at the ba of the
support column. Next, inrt a
红酒杯的正确拿法washer/head bolt into the sleeve
and hand tighten by turning the bolt
商业价值
clockwi onto the threaded hole at
the ba of the support column. U a
Phillips Head screwdriver to tighten the
asmbly.
Adhere the provided 3M
5. ™ Dual Lock™
Reclosable Fasteners on both the top
plate and the 3M wrist strap tester.
Place tester over top plate and push
down to adhere both strips of Dual Lock fasteners to each other. Make sure that
tester and top plate asmbly make a
tight bond.豌豆怎么煮
