Software:BG 6. x Revision:V 3.0 e / 06.97
PROCON GL
Type 4966
Ur Manual
Contents subject to change.
All rights regarding this document, in particular the right to reproduce, or distribute or translate it, are rerved.
No part of this document may, in any form, (by photocopying, via microfilm or any other process) be reproduced, copied, distributed, or procesd on any electronic system without prior connt in writing from STRATEC GmbH.
In ca of technical problems plea contact our rvice:
STRATEC CONTROL SYSTEMS GMBH
Durlacher Str. 35
D - 75172 Pforzheim
Tel.: (0049) 07231/1377-46旋转图形的画法
Fax: (0049) 07231/1377-25
Plea make sure to have the completed parameter list available.语文试题
TABLE OF CONTENTS i SAFETY INSTRUCTIONS iii IMPORTANT SYSTEM INSTRUCTIONS iv 1 INTRODUCTION1
1.1 About this manual1
2 GENERAL2
3 INDIVIDUAL OPERATING STATUSES3
3.1 Status : No Control3
3.2 Status : Control Activ3
3.3 Status : Blocking5
4 INDIVIDUAL OPERATING MODES6
4.1 Filling Mode6
4.2 Normal Mode7
4.3 Running Empty7
4.4 Synchronisation7
4.5 Emergency-Stop8
4.6 Service Mode8
5 OPERATION9
诲人不倦是什么意思5.1 Operation Using Terminal9
5.1.1 Setting Numerical Parameters11
5.1.2 Setting Binary Masks11
书香家庭5.2 Operation Using Integrated LCD Display13
5.2.1 Setting Nummercial Parameters14
5.2.2 Setting Binary Mask15
5.3 Operation Using a Laptop (Serial Interface)16
6 EXPLANATION OF THE DISPLAYS FOR TERMINAL17
6.1 Operation Data17
6.1.1.1 Selection Menu 119
6.1.1.2 Parametermode ( Page 1 - 9 )20
7 SERVICEMODE33
8 HOOK SWITCHES42
9 ALARM MESSAGES44
9.1 General Alarms44有残疾的英语
9.2 Min., Max. and Default Values46
9.3 Average Alarm47
9.4 Emergency-Stop Alarm47
10 INPUT AND OUTPUT SIGNALS48
10.1 Input Signals48
10.2 Output Signals51
10.2.1 Digital Outputs51
10.2.2 Analog Outputs52
10.3 Assignment of the Inputs and Outputs on the Terminal53
10.4 The Input signal MACH.READY54
10.5 Logic Table for Programming the SPC.55
11 INSTALLATION56
11.1 Calculation example for conveyor speed and parameters58
12 SERVICE NOTES60 APPENDIX A : TECHNICAL SPECIFICATIONS I APPENDIX B : MENU STRUCTURE FOR LCD DISPLAY II
Safety Instructions iii Safety Instructions
Plea do always act according to the following safety instructions, before as well as
during operation of the system:
1.The system may only be operated by authorid personnel who are instructed for
什么食物热量高
this purpo.
2.The system is designed only for operation at a voltage of 24 V DC.
3. For safety reasons the system has to be disconnected from main supply before
白菜鸡蛋汤的做法opening and reparing.
4. Only rvice staff from STRATEC or persons authorized by STRATEC are
allowed to carry out any kind of maintenance on the system.
5. STRATEC does not guarantee for the safety of staff or third persons caud by
incorrect handling of the system.
6. The system is not designed for operation in areas endangered of explosion.
7.The system is designed according to the regulations of I EC 1010-1 for electrical
systems.
>家长的评语怎么写
