spear | 打捞矛 | back pressure | 回压 |
side wall core | 井壁取芯 | drill out cement | 钻水泥塞 |
casing scraper | 套管清刮器 | explosive | 炸药 |
mill | 磨鞋 | squeeze cement | 挤水泥 |
die stamp | 铅印 | fast line spooler | 快绳排绳器 |
pin tap | 公锥 | shallow gas | 浅层气 |
box tap | 母锥 | panels | 面板 |
packer | 封隔器 | bridge plug | 桥塞个人简历模板表格 |
openner | 扩眼器 | well kick and 50BBLs pits gain | 井涌增量50桶 |
junck sub | 打捞杯 | kelly guard | 方钻杆保护接头 |
fishing over shot | 打捞筒 | blow out | 井喷 |
cutter | 割刀 | 写字姿势图片 guideline | 导向绳 |
blades | 刀臂 | guide rail | 导轨 |
pony D.C | 短钻鋌 | pick up weight | 上提重量 |
pup joint 导向标识 | 短钻杆 | 埃及景点sluck off weight | 下放重量 |
slick M.D.C | 光滑防磁钻鋌 | rotating weight | 总重量 |
fishing neck | 打捞短节 | max torque | 最大扭矩 |
perforate | 射孔 | rotating HRS | 纯钻井时间 |
no accident | 无事故 | total BHA length | 总BHA长度 |
HRS on swivel | 水龙头时间 | check crown o matic | 检查防碰天车 |
below jar W.T | 震击器以下重量 | total BHA weiht | 总BHA重量 |
HRS on jar | 震击器时间 | held safety metting on rig floor | 钻台举行安全会 |
al asmbly | 密封总成 | wear bushing | 抗磨补芯 |
total mud cost | 泥浆总消耗量 | bridge crane of the BOP | BOP叉车 |
centrifical pump | 灌注泵 | liner | 尾管 |
brine | 饱和盐 | washpipe packing | 冲管盘根 |
什么是余额宝sub a camera | 水下电视 | sand traps | 沉沙池 |
core barrel | 岩芯筒 | compensator | 补偿器 |
travly block | 游车 | 分配制crown block | 天车 |
drawworks | 钻井绞车 | stabilizer | 扶正器 |
port | 左舷 | starboad | 右舷 |
annurlar prevent | 万能防喷器 | choke/kill line | 阻流和压井管线 |
shear ram | 剪切闸板 | choke manifold | 阻流管汇 |
trip tank | 计量罐 | gas peak | 气测值 |
plug back | 打水泥塞 | dart sub | 投入式止回阀 |
nozzle | 水眼 | jetter | 喷射冲洗器 |
boost line | 加速管线 | core point | 取芯点 |
marine swivel | 水下水龙头 | trip gas | 后效气 |
prepare | 准备 | after effect | 后效 |
break CIRC | 短时循环 | mud cleaner | 泥浆清洁器 |
degasr | 除气器 | desilter | 除泥器 |
desander | 除沙器 | prior/before | 在--------之前 |
shale shaker | 震动筛 | helicopter | 直升飞机 |
gas cut mud | 气侵泥浆 | special tool | 特殊工具 |
open hole | 裸眼 | No.4 guide line brocken | 四号导向绳断掉 |
tubing | 油管 | fix | 修理 |
testing | 测试 | caving | 垮塌 |
plugged bit | 泥包钻头 | D.c twist off | 钻鋌折断 |
well off t | 井口位移 | tugger | 气动绞车 |
recover survey | 回收测斜仪 | picth | 纵摇 |
rig heading | 平台首向后 | sweel | 涌 |
wind speed | 风速 | wave | 浪 |
roll | 横摇 | heave | 升沉 |
visib | 能见度 | dir | 方位 |
concatenate函数Last anchor on rack at 0600HR |
六点最后一个锚上架 |
Start of contract at 1530HR |
下午三点半合同开始 |
End of contract at 0300HR |
早上三点合同结束 |
Rig on tow |
平台拖航 |
Rig arrived well location at 1000HR |
早上十点到达井位 |
Run anchors and frist anchor on bottom at 1100HR |
抛锚。第一个锚11点到底 |
Ballast rig to 70ft draft |
压载到70英尺 |
deballast rig |
平台卸载 |
adjust well location with pull No .1 and No.2 anchors gain |
拉1和2号锚调整井位 |
anchor tension test No.3 and No4-ok |
1和2号锚张力试验-OK |
| ps作品 |
wait slack tide |
等待平潮 |
replace upper felly cock |
替换方钻杆上阀 |
spuded time |
开钻时间 |
arrived time |
到达井位时间 |
drill 36"hole from 120m to 200m & pump 50bbls mud each connection and ream each connection once |
钻36"井眼从120米至200米,每接一拄前滑眼一次并泵入50桶泥浆 |
open 17-1/2"hole from 250m to 500m |
用17-1/2"钻头扩眼从250米至500米 |
leak off test at 500m.MW 1.2SG leak off @625psi |
破裂试验.井深500米、泥浆比重1.2SG.泄漏压力为625PSI |
ream hole from 450m to 500m |
倒划眼从450米至500米 |
core drill from 1300m to 1320m |
取芯钻进从1300米至1320米 |
collect/remove core and rvice core equipment |
收集/甩下岩芯并包装处理 |
sweep hole with 100bbl HI-VIS mud |
用100桶高粘泥浆清洗井 |
slug the hole with viscous mud |
泵送一段稠泥浆进井 |
pump 6000stks HI-VIS mud |
泵6000冲高沾泥浆 |
circulate and working on pipe |
循环并活动钻杆 |
circulate and wash from 100m to 200m |
循环清洗100米至200井段 |
circulate bottom up |
循环井底出来 |
circulate for sample 循环取样 |
flow check at 2300m due to drilling break |
流量观察因钻至2300米时突变 |
circulate for flow check |
循环观察 |
circulate and condition mud |
循环处理泥浆 |
rever circulate |
本文发布于:2023-06-26 06:46:22，感谢您对本站的认可！
本文链接：https://www.wtabcd.cn/fanwen/fan/89/1055367.html
版权声明：本站内容均来自互联网，仅供演示用，请勿用于商业和其他非法用途。如果侵犯了您的权益请与我们联系，我们将在24小时内删除。
| 留言与评论（共有 0 条评论） |
