S600.014.0017.02
S600.014.0017.02
1.多肽的作用
珠宝大家坛
1. Table of Content (2)
2.
孕妇打喷嚏Scope (3)
3. Relevant documents (3)
4.
Conditions (3)
5.
Mechanical Units (3)
6. Requirements (4)
6.1. Surface Roughness .................................................................................... 4 6.2.
Cleanliness (4)
General requirements for all supplied components ........................ 4 Surface tension relevant for all supplied components .................... 4 Additional particle classification and quantity ................................. 4 6.2.3.1. Cleanliness Level A (main galleries after machining): ................. 5 6.2.3.2.
Cleanliness Level B (other GDI components): (5)
小李将军7.
S600.014.0017.02
2. Scope
This document specifies the technical terms and requirements for purchad or
Injection systems on gasoline engines.
This specification is for internal purpo only. No part of this document may be
廉洁校园
The transmission of this specification to customers is strictly forbidden.
The transmission of this specification to suppliers of this product is only allowed if a 3.
Relevant documents
components
Additionally to the details of this specification all requirements of the relevant
otherwi specified.
Unless otherwi specified, units are according to SI (International Standard) and dimensions are metric.
S600.014.0017.02
6. Requirements
6.1. Surface Roughness
The outside surfaces of the components have to meet the surface roughness defined
6.2. Cleanliness
6.2.1.
The
contamination or coating, which would impair the processing of the components. Components have to be free from oil
支解−3N/m). Surface tension to be controlled with test ink or test pins. Ink line sticking on component surface shall bewifi连接上不能上网怎么办
Bad
on the supplier capability the below described additional cleanliness requirements can be agreed. The agreement needs to be done at the beginning of
∙ Component weight ≤ 50 grams
→∙ Component weight ≥ 50 grams → 5 components per filter
Test shall be carried out according VDA 19. Following values shall not exceed by
S600.014.0017.02
6.2.3.2. Cleanliness Level B (other GDI components):
Following elements can influence the brazing quality or cau corrosion. Therefore
GDI components may not been tumble deburred in a media which had contact to aluminium parts before.
擦黑板的英文Note: Silicium is part of the ba material alloy composition of 1.4301 and 1.4305.