英文焊接手册Welding handbook

更新时间:2023-06-12 20:09:37 阅读：评论：0

Document provided by IHS Licene=Shell Services International B.V./5924979112, 08/26/2004 23:33:59 MDT Questions or comments about this message: plea call 1

the Document Policy Group at 303-397-2295.

电视的英语怎么说

2NOTE:Although care was taken in choosing and prenting the data in this guide, AWS cannot guarantee that it is error free. Further, this guide is not intended to be an exhaustive treatment of the topic and therefore may not include all available information, including with respect to safety and health issues. By publishing this guide, AWS does not insure anyone using the information it contains against any liability or injury to property or persons arising from that u.© 2004 by American Welding Society. All rights rerved.Printed in the United States of America

Provided by IHS under licen with AWS Document provided by IHS Licene=Shell Services International B.V./5924979112, 08/26/2004 23:33:59 MDT Questions or comments about this message: plea call the Document Policy Group at 303-397-2295.--`````,`,,``,`,,```,,,`,``-`-`,,`,,`,`,,`---

The inspection requirements for the fabrication and welding of steel structures are very extensive. This Pocket

Handbook has been developed to provide a uful tool for inspectors to carry in their pockets or tool kits so that lected pertinent portions of the AWS Structural Welding Code—Steel, D1.1/D1.1M:2004, can be easily

referenced at the job site. Underlining is as shown in the code.

This publication is not to be considered as a substitute for the D1.1 code book. Rather, the Handbook is provided

as a supplemental aid for the “deckplate” inspector. Only the complete code should be considered as the official

document to ensure that all of the quality attributes required for structural fabrication are performed correctly and completely.

To assist the inspector, or other ur, in verifying conformance to D1.1, the paragraph references, the table num-bers, and the figure numbers contained in this book are directly from the D1.1/D1.1M:2004 code. In addition, page numbering in this handbook is cross-referenced to reflect both the current page and the corresponding page from the D1.1/D1.1M:2004 code, parated by a “/

.” This will provide an easy cross reference for the ur to ensure that the complete requirements are understood when questions develop during the cour of any inspection.

Introduction

Document provided by IHS Licene=Shell Services International B.V./5924979112, 08/26/2004 23:33:59 MDT Questions or comments about this message: plea call the Document Policy Group at 303-397-2295.

博士专家推荐信

埃迪蒙托

理想青年

元宵节创意文案

幼儿园课后反思

Requirements for Transitions Between Materials of Unequal Thickness (5)

Thermal Cutting and Access Hole Requirements (9)

Tolerance of Joint Dimensions (13)

Dimensional Tolerances of Welded Structural Members (19)

Ba Material Surface Requirements (25)

Weld Profile Requirements (26)

Acceptance Criteria for Visual Inspection of Welds (32)

Index (37)

Table of Contents

Document provided by IHS Licene=Shell Services International B.V./5924979112, 08/26/2004 23:33:59 MDT Questions or comments about this message: plea call the Document Policy Group at 303-397-2295.

`个人全面发展