日本波子汽水SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The u of this report is entirely voluntary, and its applicability and suitability for any particular u, including any patent infringement arising therefrom, is the sole responsibility of the ur.”
SAE reviews each technical report at least every five years at which time it may be reaffirmed, revid, or cancelled. SAE invites your written comments and suggestions.
过敏性鼻炎吃什么QUESTIONS REGARDING THIS DOCUMENT: (724) 772-8512 FAX: (724) 776-0243
离职率怎么算
TO PLACE A DOCUMENT ORDER; (724) 776-4970 FAX: (724) 776-0790
圆葱炒鸡蛋的做法SAE WEB ADDRESS www.sae
Copyright 1997 Society of Automotive Engineers, Inc.
All rights rerved.Printed in U.S.A.
-2-
香港爱情片FIGURE 1—THREE DIMENSIONAL REFERENCE SYSTEM
4.Requirements—The minimum of three fiducial marks shall be specified, one on each side of the "Y" plane
跑步热身
(usually symmetrical for convenience) and an additional one forward or rearward of the first two, all as far apart as allowable and usable.
5.Procedure
欢度国庆黑板报5.1Position the motor vehicle on a level surface.
5.2Adjust motor vehicle height and attitude to a ground reference plane as defined by the manufacturer according to the fiducial marks.
自学能力5.3Locate the dimension reference system on the motor vehicle. Locations of interest can now be dimensioned in the actual motor vehicle with respect to the designed motor vehicle using coordinates in the three-dimensional reference system.
6.Notes
6.1
Marginal Indicia—The change bar (l) located in the left margin is for the convenience of the ur in locating areas where technical revisions have been made to the previous issue of the report. An (R) symbol to the left of the document title indicates a complete revision of the report.PREPARED BY THE SAE HUMAN ACCOMMODATION
AND DESIGN DEVICES TECHNICAL COMMITTEE
Rationale—Not applicable.
Relationship of SAE Standard to ISO Standard—Not applicable.
Application—This SAE Recommended Practice describes a procedure for locating the three-dimensional reference system on a motor vehicle as built.
Reference Section—There are no referenced publications specified herein.
Developed by the SAE Human Accommodation and Design Devices Technical Committee
