特种船船首定位桩收放操作规程
The Collecting And Releasing Procedures Of The Bow Spudpole
1. 放定位桩操作
Releasing the spudpole operation
1.1. 预先通知机舱确认是否有足够的电力供应（必要时加开辅机）。
Advance notice the engine room to confirm whether there is sufficient electricity supply (if necessary, additional auxiliary)博学之
1.2. 检查液压油柜油位。
Check hydraulic oil tank oil level
1.3. 根据液压泵浦间液压油泵开关标识正确启动定位桩缆车油泵。
简历照片尺寸According to the switch label of hydraulic pump in the hydraulic pumping room, start the sp
udpole cable car pump correctly
1.4. 合上定位桩缆车离合器，脱开刹车。
Connect the spudpole cable car clutch, withdraw the brake
1.5. 解掉固定松紧螺栓。
Remove the fixed and elastic bolt
1.6. 使用首甲板控制箱内的控制手柄操纵定位桩，缆车收紧定位桩钢丝。
U the control handle in the fore deck control box to manipulate spudpole, and cable car tightening spudpole wire
1.7. 解掉固定定位桩的闸刀，备好后，告知船长。
Remove the switch blade fixed the spudpole, after ready, inform the master
1.8. 按船长的命令迅速松钢缆使定位桩插入海底固定船首。
According to the captain's orders quickly loo wire in order to make the spudpole inrt undera to fixe the bow
1.9. 使用完毕后刹紧刹车，脱开离合器。
After using brake tightly, withdraw the clutch
1.10. 停泵并通知机舱。
Stop the pump and inform the engine room
注意：Notice
1. 通常缆机油泵启动运转几分钟后再用，长时间使用缆机还应启动缆机冷却水泵。
Usually u the cable machine oil pump after it started-up and ran veral minutes, Long-time using cable machine should also start cable machine cooling water pump.
2. 艏定位桩闲敲棋子落灯花(Spudpole)恐惧新星：重24T，总长度18M，伸出船底的长度不能超过14M，船底富余水深不超过8M妍字取名的寓意是什么，适泊位情况方可选择性操作使用。
The bow spudpole)：weight 24T，length 18M，Stretching out the the ship bottom length should not exceed 14 meters, Bottom surplus depth is less than 8M，Can lectively operation according to the berth situation.
1. 收定位桩操作
Collect the spudpole operation
1.1. 预先通知机舱确认是否有足够的电力供应（必要时加开辅机）。
Advance notice the engine room to confirm whether there is sufficient electricity supply (if necessary, additional auxiliary)
1.2. 根据液压泵浦间液压油泵开关标识正确启动定位桩缆车油泵。
According to the switch label of hydraulic pump in the hydraulic pumping room, start the spudpole cable car pump correctly.
1.3. 合上定位桩缆车离合器，松开刹车。
随笔800
Connect the spudpole cable car clutch, withdraw the brake
1.4. 使用首甲板控制箱内的控制手柄操纵定位桩缆车，绞缆收进定位桩。
U the control handle in the fore deck control box to manipulate spudpole cable car, Strand cable and collect into the spudpole
1.5. 定位桩收至固定位置后放好闸刀。
After the spudpole move to a fixed position, put the switch blade
1.6. 松定位桩靠架在闸刀上，打上固定松紧螺栓。
Loo the spudpole lean against the switch blade, then screw in the bolt
1.7. 刹紧缆车刹车，脱开离合器。
Brake the cable car brake tightly, withdraw the clutch
1.8. 停泵并通知机舱。
Stop the pump and inform the engine room.
注意Notice：
1. 通常缆机油泵启动运转几分钟后再用，长时间使用缆机还应启动缆机冷却水泵。
Usually u the cable machine oil pump after it started-up and ran veral minutes, Long-time using cable machine should also start cable machine cooling water pump.故宫100观后感
2. 定位桩总长度18米。
The spudpole total length is 18 meters。
