WIRING DIAGRAM
Page
1.General Description (1)
2.Wiring Diagram (10)
(1)POWER SUPPLY ROUTING (10)
(2)ENGINE CONTROL SYSTEM(SOHC) (14)
(3)ENGINE CONTROL SYSTEM(2.0 DOHC NA) (18)
(4)ENGINE CONTROL SYSTEM(2.5 ) (22)
(5)ENGINE CONTROL SYSTEM(Turbo vehicle) (26)
(6)VDC CONTROL SYSTEM (30)
(7)STARTER MOTOR SYSTEM(MT vehicle) (32)
(8)STARTER MOTOR SYSTEM(AT vehicle) (33)
(9)KEYLESS ENTRY SYSTEM(With hook) (34)
(10)KEYLESS ENTRY SYSTEM(Without hook) (35)
(11)STOP LIGHT SYSTEM (36)
动员讲话(12)BACK-UP LIGHT SYSTEM (37)
(13)TURN SIGNAL AND HAZARD SYSTEM (38)
(14)LIGHTING SYSTEM(CLEARANCE,LICENSE AND ILLUMI.) (40)
(15)COMBINATION METER (42)
(16)FUEL GAUGE SYSTEM (44)
(17)INTERIOR LIGHT AND DOOR WARNING LIGHT (45)
(18)REAR WIPER AND WASHER SYSTEM(With intermittent) (46)
(19)REAR WIPER AND WASHER SYSTEM(Without intermittent) (47)
(20)POWER WINDOW SYSTEM (48)
(21)REMOTE CONTROLLED REARVIEW MIRROR SYSTEM (50)
(22)REAR WINDOW DEFOGGER SYSTEM (51)
(23)CARGO FAN SYSTEM (52)
(24)ELECTRICAL CONTROLLED MUFFLER SYSTEM (53)
(25)BODY GROUND SYSTEM (54)
3.Electrical Wiring Harness and Ground Point (55)
(1)BULKHEAD WIRING HARNESS(Compartment) (56)我是钢铁侠英文
(2)INSTRUMENT PANEL WIRING HARNESS (58)
(3)DOOR CORD (60)
阁中帝子今何在
(4)REAR WIRING HARNESS (62)
(5)REAR WIRING HARNESS AND REAR GATE CORD (64)
1.General Description
This Manual describes the symbols and abbreviations ud
in electrical wiring diagrams(schematics).The symbols
and abbreviations are ud to indicate connector
configuration,terminal number,male and female
connections,wire color coding,and other important distinc-
tions.
CAUTION:
¼Unauthorized changes in electrical wiring configura-
tion together with the connecting of unauthorized
equipment to the basic wiring configuration(har-
ness)are a primary cau of vehicle fires.Under no
circumstances should additional electrical equipment
be connected to the harness.Neither should some
other piece of electrical equipment be ud as the
power supply.U only the specified terminals when
making connections.
¼Note the specified terminal maximum capacity.
Under no circumstances should this capacity be
exceeded.
1.Viewing the connector
Connector terminal positions are always shown from the
harness side.Determine the viewing direction as it is
shown in the wiring diagram.
58T-M59
2.Connector indications
¼Female connectors are shown as a box constructed of
a single continuous line.Male connectors are shown as a
box constructed of a continuous double line.
¼Connector boxes are divided into smaller boxes.The
number of smaller boxes corresponds to the number of
connector terminals.The numerical characters inside the
smaller boxes indicate terminal position.
¼A small projection at the top of the connector box indi-
cates that the connector is equipped with a lock.
风字的笔画58T-M60
3.Connector designation and numbering
Connector designations shown in the wiring diagram matches the connectors in the figures under Electrical Wir-ing Harness and Ground Point.To determine connector position on an actual vehicle,refer to Electrical Wiring Har-ness and Ground Point.
F Front
E Engine and transmission B Bulkhead i Instrument panel D Rear gate cords S Roof cords AB Airbag R
Compartment
4.Switch and relay indications
口罩英语All switches and relays shown in the diagram are in the OFF position (no current flow).
¼N.O =Normally open (Contacts parated with no cur-rent flow)钱钟书名言
¼N.C =Normally clo (Contacts clod with no current flow)
5.Ground indications
Ground indications are as shown in the figure.Ground installation positions are shown in a parate diagram.
58T-M61
58T-M62
58T-M63
G6M0203
6.Circuit diagram color coding
Alphabet color symbol
Color L Blue B Black Y Yellow G Green R
Red W White Br Brown V Violet Lg Light green Or Orange Sb Sky blue Gr Gray P
Pink
Wiring having two colors is indicated by two alphabet char-acters.The character at the left shows the reference color.The character at the right shows the marking color.Refer to the example.
67K-M40
G6M0202
7.Shielded wire indication
Some electronic control equipment wiring is shielded to
prevent harmful stray radio wave interference.Shielded
wire is indicated by a broken line in the diagram.Refer to
the figure.
58T-M65
Shielded wire consists of vinyl-covered electric wire sur-
rounded by metallic material.The metallic material is
grounded to prevent static electricity build-up.
8.Abbreviation list
外贸论文Alphanumeric symbol Definition Alphanumeric symbol Definition IG Ignition PASS Passing
ACC Accessory MG Magneto
ST Starter WASH Windshield washer
B Battery D,DN Down(Direction)
E Ground(Earth)U,UP Up(Direction)
LH Left side AD Automatic down
RH Right side AU Automatic up
ABS Anti-lock brake system Lo Low(Position)
SBF Slow-blow fu Mi Middle(Position)
ISC Idle speed control INT Intermittent(Position)
穆旦的诗
M Motor FRE/REC FRESH/RECIRC
SW Switch MT Manual transmission
OP Optional part/Open S Shaft
AT Automatic transmission SR Sunroof
M/B Main fu box F Front
F/B Fu&relay box R Rear
A/C Air conditioning Air bag Airbag
SMJ Super multiple junction A/S Air suspension
VDC Vehicle dynamic control Illumi.Illumination