[PREAMBLE]
E/ECE/324}Rev.2/Add.115/Corr.3/Amend.1/Amend.2
E/ECE/TRANS/505}
4November2008
AGREEMENT
CONCERNING THE ADOPTION OF UNIFORM TECHNICAL PRESCRIPTIONS FOR WHEELED VEHICLES,EQUIPMENT AND PARTS WHICH CAN BE FITTED AND/OR BE USED ON WHEELED VEHICLES AND THE CONDITIONS FOR RECIPROCAL RECOGNITION OF APPROVALS GRANTED ON THE BASIS OF THESE PRESCRIPTIONS*/ (Revision2,including the amendments which entered into force on16October1995)
_________
Addendum115:Regulation No.116
Corrigendum3–Amendment1–Amendment2
Date of entry into force:6April2005
Corrigendum1to the original version of the Regulation,subject of Depositary Notification
C.N.1277.2005.TREATIES-15dated21December2005[R116c1-1] Supplement1to the original version of the Regulation-Date of entry into force:10October
2006[R116s1-2]
Supplement2to the original version of the Regulation-Date of entry into force:15October
2008[R116s5-3]
UNIFORM TECHNICAL PRESCRIPTIONS CONCERNING THE PROTECTION OF MOTOR VEHICLES AGAINST UNAUTHORIZED
USE
_________
UNITED NATIONS
Regulation No.116
UNIFORM TECHNICAL PRESCRIPTIONS CONCERNING THE PROTECTION OF MOTOR VEHICLES AGAINST UNAUTHORIZED USE
CONTENTS
REGULATION
1.Scope
2.Definitions:General
3.Application for approval
4.Approval
5.PART I:APPROVAL OF A VEHICLE OF CATEGORY M1AND N1WITH REGARD TO
ITS DEVICES TO PREVENT UNAUTHORIZED USE
5.1.Definitions
5.2.General specifications
5.3.Particular specifications
5.4.Electromechanical and electronic devices to prevent unauthorized u
6.PART II:APPROVAL OF VEHICLE ALARM SYSTEMS
6.1.Definitions
6.2.General specifications
6.3.Particular specifications
6.4.Operation parameters and test conditions
6.5.Instructions
70周年手抄报7.PART III:APPROVAL OF A VEHICLE WITH REGARD TO ITS ALARM SYSTEM
7.1.Definitions
遗精怎么治疗7.2.General specifications
7.3.Particular specifications
7.4.Test conditions
7.5.Instructions
8.PART IV:APPROVAL OF IMMOBILIZERS AND APPROVAL OF A VEHICLE WITH
REGARD TO ITS IMMOBILIZER
8.1.Definitions
8.2.General specifications
8.3.Particular specifications
8.4.Operation parameters and test conditions
8.5.Instructions
9.Modification of the type and extension of approval
10.Conformity of production procedures
11.Penalties for non-conformity of production
12.Production definitely discontinued
13.Transitional provisions
14.Names and address of technical rvices responsible for conducting approval tests,
英式教育
and of administrative departments
ANNEXES
Annex1-Information document:
Part1:
Part1:in accordance with paragraphs5,7and8as appropriate of Regulation No.厦门环岛路
116relating to ECE system type approval of a vehicle type with regard to the
devices to prevent unauthorized u
Part2:in accordance with paragraph6of Regulation No.116relating to ECE
component type approval of an alarm system
Part3:in accordance with paragraph8of Regulation No.116relating to ECE
component type approval of an immobilizer system
绿化合同
Annex2-Communication concerning approval granted,extended,refud,withdrawn,production definitively discontinued:
Part1:of a vehicle type with regard to its devices to prevent unauthorized u
pursuant to Regulation No.116
Part2:of a component type as an alarm system pursuant to Regulation No.116
Part3:of a component type as an immobilizer pursuant to Regulation No.116 Annex3-Arrangements of approval marks
Annex4-Part1:Wear producing test procedure for devices to prevent unauthorized u acting on the steering
Part2:Test procedure for devices to prevent unauthorized u acting on the steering using a torque limiting device
人力资源年终总结Annex5-(Rerved)[R116c1-4]
Annex6-Model of certificate of conformity
Annex7-Model of installation certificate
Annex8-Test of systems for the protection of the pasnger compartment
Annex9-Electromagnetic compatibility
Specifications for mechanical key switches
Annex10
-
[TEXT]
[Regulation]
1.SCOPE
This Regulation applies to:
1.1.PART I-Approval of a vehicle of category M1and N11/with regard to its devices to
prevent unauthorized u.
1.2.PART II-Approval of vehicle alarm systems(VAS)which are intended to be
permanently fitted to vehicles of category M1and tho of category N1with a maximum
mass of not more than2tonnes1/.
1.3.PART III-Approval of vehicles of category M1and tho of category N1with a
maximum mass of not more than2tonnes,with regard to their alarm system(s)2/.
1.4.PART IV-Approval of immobilizers and vehicles of category M1and vehicles of
category N1with a maximum mass of not more than2tonnes with regard to
immobilizers2/1/.
1.5.The fitting of devices specified under Part I to vehicles of other categories is optional
but any such device fitted is required to comply with all relevant provisions of this
Regulation.
1.6.The fitting of devices specified under Parts III and IV to vehicles of other categories,or
to N1category vehicles with a maximum mass exceeding2tonnes,is optional but any
such device fitted is required to comply with all relevant provisions of this Regulation. 1.7.At the request of the manufacturer,Contracting Parties may grant approvals under
Parts I to IV to vehicles of other categories and devices for fitment to such vehicles.
1.8.At the time of application of this Regulation,Contracting Parties shall declare which
parts of the Regulation they intend to mandate in their territory for each category of
vehicles3/.
2.DEFINITIONS:GENERAL
2.1."Manufacturer"means the person or body who is responsible to the approval authority
for all aspects of the type approval process and for ensuring conformity of production.It is not esntial that the person or body is directly involved in all stage of the
construction of the vehicle,system,component or parate technical unit which is the
subject of the approval process.
3.APPLICATION FOR APPROVAL
3.1.The application for approval of a vehicle or component type with regard to this
Regulation shall be submitted by the manufacturer.
3.2.It shall be accompanied by an information document in accordance with the model
shown in Annex1,Part1,2or3as appropriate.
3.3.Vehicle(s)/component(s)reprentative of the type(s)to be approved shall be
submitted to the technical rvice responsible for conducting the approval tests.
随堂测验
4.APPROVAL
4.1.If the type submitted for approval to this Regulation meets the requirements of the
relevant part(s)of this Regulation,approval of that type shall be granted.
4.2.An approval number shall be assigned to each type approved.Its first two digits(at
prent00,corresponding to the Regulation in its original form)shall indicate the ries of amendments incorporating the most recent[major]technical amendment made to the Regulation at the time of issue of the approval.The same Contracting Party shall not
assign the same number to another type of vehicle or component as defined in this
Regulation.
4.3.Notice of approval or of extension of approval of a type pursuant to this Regulation
shall be communicated to the Contracting Parties to the Agreement applying this
Regulation by means of a form conforming to the model in Annex2,Part1,2or3as
appropriate to this Regulation.
4.4.There shall be affixed,conspicuously and in a readily accessible place specified on the
approval form,to every vehicle or component conforming to a type approved under this Regulation,an international approval mark consisting of:
4.4.1.a circle surrounding the letter"E"followed by the distinguishing number of the country
which has granted approval4/,and
4.4.2.the number of this Regulation,followed by the letter"R",a dash and the approval
number,to the right of the circle prescribed in paragraph4.4.1.,and
4.4.3.an additional symbol:
4.4.3.1."A"in the ca of an alarm system(Part II);
4.4.3.2."I"in the ca of an immobilizer(Part IV);
4.4.3.3."AI"in the ca of a combination of an alarm system and an immobilizer;
4.4.3.4."L"in the ca of a vehicle approval as regards its devices to prevent unauthorized u
(Part I);
4.4.3.
5."LA"in the ca of a vehicle approval as regards its devices to prevent unauthorized
u(Part I)combined with an alarm system;
4.4.3.6."LI"in the ca of a vehicle approval as regards its devices to prevent unauthorized
u(Part I)combined with an immobilizer;
4.4.3.7."LAI"in the ca of a vehicle approval as regards its devices to prevent unauthorized
u(Part I)combined with an alarm system and an immobilizer.
4.5.If a type conforms to a type approved,under one or more other Regulations annexed to
the Agreement,in the country which has granted approval under this Regulation,the
symbol prescribed in paragraph4.d not be repeated;in such a ca,the
Regulation under which approval has been granted in the country which has granted
approval under this Regulation shall be placed in vertical columns to the right of the
symbol prescribed in paragraph4.4.1.
4.6.The approval mark shall be clearly legible and be indelible.
4.7.In the ca of a vehicle,the approval mark shall be placed clo to or on the vehicle
data plate affixed by the manufacturer.
4.8.In the ca of a component approved parately as an alarm system or immobilizer or
both,the approval mark shall be affixed by the manufacturer to the major element(s)of the device.
4.9.Annex3to this Regulation gives examples of arrangements of approval marks.古装剧排行榜
4.10.As an alternative to the approval mark described in paragraph4.4.above,a certificate
of conformity shall be issued for every VAS and immobilizer offered for sale.
Where a VAS and/or immobilizer manufacturer supplies an approved unmarked VAS
and/or immobilizer to a vehicle manufacturer,for fitment by that manufacturer as
original equipment for a vehicle model or range of vehicle models,the VAS and/or
immobilizer manufacturer shall supply a number of copies of the certificate of
conformity to the vehicle manufacturer,sufficient for that manufacturer to obtain the
vehicle approval to Parts II,IV and V,as appropriate,of this Regulation.
If the VAS or immobilizer is made up of parate components,its main component(s)
shall bear a reference mark and the certificate of conformity shall provide a list of such reference marks.
A model of the certificate of conformity is given in Annex6to this Regulation.
5.PART I:APPROVAL OF A VEHICLE OF CATEGORY M1AND N1WITH REGARD TO
ITS DEVICES TO PREVENT UNAUTHORIZED USE
5.1.DEFINITIONS
For the purpo of Part I of this Regulation,
5.1.1."Vehicle type"means a category of motor vehicles which do not differ in such esntial
respects as:
5.1.1.1.the manufacturer's type designation,
5.1.1.2.the arrangement and design of the vehicle component or components on which the
device to prevent unauthorized u acts,
5.1.1.3.the type of device to prevent unauthorized u.
