1
2004.2
1.9(
2.0M a x )
2.4(2.5M a x )3(
3.2M a x )
U.FL-LP(V)-040
U.FL-LP-040U.FL-LP-066
E.FL-LP-040E.FL-LP-066
U.FL
E.FL
s Features
1.Extremely Small Occupied Mounting Area
Reduced board space requirement by 18% to 7.7mm 2, when compared with Hiro ’s E.FL connectors.
2.Light Weight
One of the world’s lightest coaxial connectors.Receptacle: 15.7mg
3.Frequencies of Up to 6GHz
To meet the frequency requirements of a wide variety of miniature equipment, the connectors offer high frequency performance from DC to 6 GHz.4.Board Placement with Automatic Equipment Supplied on tape-and-reel packaging.
5.U of Ultra-fine Teflon Cable
Several of ultra-fine single and double shielded Teflon ®coaxial cables terminate to U.FL plug.
6. Simple Disconnection
Dedicated tool allows reliable un-mating of the plug.
7.Ur Friendly Mating Operation
Tactile lock feeling ensures and confirms reliable connection.
s Applications
Mobile phones, Wireless LAN, Mini-PCI, Bluetooth, PDA, GPS,electronic measuring instruments, etc.
*Teflon is a registered trademark of DuPont.
Mated Height Comparison
(With E.FL ries)
q Space Factor of Mated Connector
2s
Product Specifications
*V.S.W.R. Measurement System
The above V.S.W.R. standard values were measured using the measurement connection shown below.
Note 1: Cable type connectors were measured with SMA conversion adapters
attached to both ends of the harness product of a suitable 100cm cable.
Note 2: Board type connectors were mounted to a 50Ωglass epoxy board and
measurements were conducted with SMA conversion adapters attached.
s Material/Finishes
3
s Receptacles
Note 1: Receptacles of (01) specification are sold by the
bag with 100 pieces per bag. Plea order in pack units.
Note 2: Receptacles of (10) specification are sold by the
reel (which contains 2,500 pieces). Plea order in reel units.
Note 3: This area may be covered by insulating material.
q Packaging Specifications
Embosd Carrier Tape Dimensions
Reel Dimensions
GND
GND
GND GND Cut Out Prohibition Area
Recommended PCB mounting pattern
SIG SIG Ø2
32.60.6
1.25
0.35
1.05±0.051±0.051±0.05
2.2±0.05
4±0.051.9±0.05
1.2M a x (N o t e 3)(3.1)
2.61.8
1.75±0.1
12±0.3
8±0.1
2±0.14±0.10.31.6
Center contact
Unreeling direction
5.5±0.1
Ø1.5
+0.1 0
1.8
14Ø13Ø21
Ø330±2
4
s Cable Asmbly (Plug)
* SA : Silver plated annealed copper wire, TA : Tin plated annealed copper wire, TAT : Tin plated copper wire alloyed with tin
5
s How to Specify Plug Cable Asmbly
Dimensions of U.FL Series asmbly products should be made as indicated below.
Plea contact Hiro Sales Reprentative for cable length and cable end treatment.
