VEHICLE下发通知
RECO
SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The u of this report is entirely voluntary, and its applicability and suitability for any particular u, including any patent infringement arising therefrom, is the sole responsibility of the ur.”
SAE reviews each technical report at least every five years at which time it may be reaffirmed, revid, or cancelled. SAE invites your written comments and suggestions. Copyright © 2005 SAE International
All rights rerved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwi, without the prior written permission of SAE.
2.5Other Referenced Documents
2.5.1SAE P UBLICATIONS
Available from SAE, 400 Commonwealth Drive, Warrendale, PA 15096-0001.
SAE J2223-2—Connections for On-Board Road Vehicle Electrical Wiring Harness
SAE J1127—Battery Cable
lo的过去式野歌李贺SAE J1128—Low Tension Primary Cable
SAE/USCAR-23—Road Vehicle—60 V and 600 V Single Core (ISO/Metric) Cables—Dimensions, Test Methods and Requirements
贴对联的由来
2.6Related Publications柴胡舒肝散
The following publications are provided for information purpos only and are not a required part of this document.
2.6.1SAE P UBLICATIONS
粉色百合
Available from SAE, 400 Commonwealth Drive, Warrendale, PA 15096-0001.
SAE J1654—High Voltage Primary Cable
SAE J1673—Recommended Practice for High Voltage Wiring Asmblies
3.Definitions and Abbreviations
3.1Definitions高考励志图片
Terms defined in the definitions or abbreviations ctions are capitalized (i.e. Room Temperature, PLR, etc.) See SAE J2223-2 for additional definitions applicable to this document.
3.1.1B REAKDOWN
The failure of the dielectric of an insulation under the effect of an excessive electric field and/or by physical or chemical deterioration of the dielectric material.
3.1.2C ONNECTOR
A component which terminates conductors for the purpo of providing connection and disconnectio
n to a suitable mating component. Connectors are designed to be connected and disconnected in the de-energized state unless otherwi specified. See Appendix C.
3.1.3C ONNECTOR H OUSING
The part of a connector into which the inrt and contacts are asmbled.
3.1.4C ONTACT
红硅硼铝钙石
Conductive element in a component that mates with a corresponding element to form an electrical path.
