云路社区
维吾尔族习俗, , , and –.
汤池n )/100 ´ 1 h for HEV appl
I max and power can be calcu Regener I t for BEV application
A
and Figure 3b.
at学医
.If the voltage reaches the N is a value (1/h)NOTE The value of N = 3/h is an specifications of commercialized BEVs.ed derived from equation (12) is larger than the maximum power of cell specified by t test power shall be defined as 80 % of the maximum power at room temperature and a by the manufacturer. Power value actually ud shall be reported.
Figure 4 – Dyna
profile A for BEV cycle test Step 4 - Discharge the cell following the dynamic dis (hill climbing profile) specified in Table 4 and Figure 5 for one time. The test p calculated using equation (12).If the voltage reaches the lower limit specified by during step 4, the test shall be discontinued notwithstanding the stipulation in 7cell performance shall be measured at this point as specified in 7.7.1.2 c).If the frequently reaches the lower limit voltage during charge/discharge step 16, the di duration can be changed appropriately. The actual test values shall be reported ac Dynamic discharge profile B for BEV cycle testFigure 5 – Dynamic discharge pr cycle test Step 5 - Discharge the cell following the dynamic discharge profile A sp and Figure 4 until the overall discharge capacity including step 3 and step 4 reac % of initial C D at .If the temperature of cell reaches the upper limit specified b during ste
p 5, the duration of charge/discharge step Table 3 can be extended to a The actual duration time shall be reported.If the voltage reaches the lower limit manufacturer during step 5, the test shall be discontinued notwithstanding the sti d), and the cell performance shall be measured at this point as specified in 7.7.1measurement of performanceAfter every completion of the repetition from step 1 to days, the performanceof cell shall be measured as specified in 7.7.1.1. The accumu 1 to step 7.7.1.2 b) shall also be reported. The dynamic discharge capacity shall 2 K only.d) Termination of testThe cycle life test shall be terminated when either conditions is satisfied. Otherwi back to 7.7.1.2 a) and repeat the test. Conditi quence from 7.7.1.2 a) to 7.7.) is repeated 6 times.Condition B – When any of t measured in 7.7.1.2 c) is decread to less than 80 % of the initial value.Conditi temperature of cell reaches the upper limit agreed between the manufacturer and th the test.The number of implemented times of each profile and cycle during the test test
stipulation in 7.7.1.2 d), and the cell performance shall be measured at this poin 7.7.1.2 c).If the temperature of cell reaches the upper limit specified by the man step 3, the duration of charge/discharge step Table 3 can be extended to an appro actual duration time shall be reported.In this profile, the test power shall be ca equation (12)P max = N W ed (12)where P max is the test power (W);N is a value (1/h)
学校广告校庆主持词凉瓜炒牛肉
NOTE The value of N = 3/h is an Array
Figure 4 – Dyna
风水梨
Q c using
I n is d
I and the disch W= (14)wher
η c is coulomb efficiency
η
This paragraph i
