- MS842P -
Ur’s Manual
Version 1.6
北京鑫泰维科技发展有限公司北京鑫泰维科技发展有限公司
Preface
This manual explains how to install, operate and maintain the MS842P wireless scanner.
No part of this publication may be reproduced or ud in any form, or by any electrical or mechanical means, such as photocopying, recording, or information storage and retrieval systems, without permission in writing from the manufacturer. The material in this manual is subject to change without notice.
© Copyright 2013 Unitech Electronics Co., Ltd. All rights rerved.
Unitech global website address:
Bluetooth is a registered trademark of Bluetooth SIG.
Regulatory Compliance Statements
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. The limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, us and can radiate radio frequency energy and, if not installed and ud in accordance with the instructions, may cau harmful interference with radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cau harmful interference with radio or television reception, which can be determined by turning the equipment off and on, the ur is encouraged to try to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increa the paration between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
1. This Transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
怎么看笔记本显卡
2. This equipment complies with FCC RF radiation exposure limits t forth for an
uncontrolled environment. To maintain compliance with FCC RF exposure requirements, avoid direct contact to the transmitting antenna during transmitting.
3. Any changes or modifications (including the antennas) made to this device that are not
expressly approved by the manufacturer may void the ur’s authority to operate the
equipment.
FCC Label Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cau harmful interference, and
2. This device must accept any interference received, including interference that may cau
undesired operation.
RF Radiation Exposure Statement
For body contact during operation, this phone has been tested and meets FCC RF exposure guidelines when ud with an accessory that contains no metal and that positions the handt a minimum of 1.5 cm from the body. U of other accessories may not ensure compliance with FCC RF exposure guidelines.
Canadian Compliance Statement
This Class B Digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numerique de la clas B respecte les exigences du Reglement sur le material broilleur du Canada.
European Conformity Statement
Declaration of Conformity with regards to the R&TTE 1999/5/EC and EMC 89/336/ EEC directives.
wps图片编辑>鱿鱼的做法
RoHS Statement
This device conforms to RoHS (Reduction Of
Hazardous Substances) European Union
regulations that t maximum concentration limits
on hazardous materials ud in electrical and
electronic equipment. Taiwan NCC Warning Statement雾化药有哪些
交通部電信總局低功率電波輻射性電機管理辦法 (930322)
根據交通部低功率管理辦法規定：
第十二條 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更
頻率、加大功率或變更原設計之特性及功能。
第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應
立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之
無線電通信。
沮丧的意思是什么低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
跑步的姿势
減少電磁波影響，請妥適使用 Lar Information
The Unitech MS842P is certified in the U.S. to conform to the requirements of DHHS/CDRH 21CFR Subchapter J and to the requirements of IEC 825-1. Class II and Class 2 products are not considered to be hazardous. The MS842P contains internally a Visible Lar Diode (VLD) who emissions do not exceed the maximum limits as t forth in the above regulations. The scanner is de
signed so that there is no human access to harmful lar light during normal operation, ur maintenance or prescribed rvice operations.
The lar safety warning label required by the DHHS/IEC for the MS842P’s optional lar scanner module is located on the memory compartment cover, on the back of the unit. CAUTION! U of controls or adjustments or performance of procedures other than tho
specified herein may result in hazardous lar light. U of optical instruments with
the scanner, including binoculars, microscopes, and magnifying glass, with will
increa eye damage. This does not include eyeglass worn by the ur.
Battery Notices
olympicThe MS842P is equipped with a Lithium-Ion battery. The battery will discharge after an extended period of no u.
When the battery is discharged, recharge the unit for some 4.5 hours in order to fully charge the battery.
Note: To guarantee optimal performance, it is advid that rechargeable batteries be replaced every year, or when 500 charge/discharge cycles are achieved. It is normal that the
battery balloons or expands beyond one year or the maximum of 500 cycles. Although it does not cau harm, it cannot be ud again and must be dispod of according to the location's safe battery disposal procedures.
If the performance, of a Lithium-Ion battery, decrea is greater than 20% in, the battery is at the end of its life cycle. Do not continue to u, and ensure the battery is dispod of properly.
The length of time that a battery lasts depends on the battery type and how the device is ud. Conrve the battery life by doing the following:
Avoid frequent full discharges becau this places additional strain on the battery. Several partial discharges with frequent recharges are better than a full discharge. Recharging a partially charged lithium-Ion battery does not cau harm becau there is no memory effect.
Keep the lithium-Ion battery cool. Avoid a hot car. For prolonged storage, keep the battery at a 40% charge level.
鸡冲什么生肖Do not leave the lithium-Ion battery discharged and unud for an extended period becau the battery will wear out and the longevity of the battery will be at least half of the one with frequent recharges.
Battery charge notice
It is important to consider the environment temperature when the Lithium-Ion battery pack is charged.
Charging is most efficient at normal room temperature or in a slightly cooler environment. It is esntial that batteries are charged within the stated range of 0°C to 40°C. Charging batteries outside of the specified range could damage the batteries and shorten their charging life cycle.
CAUTION! Do not charge batteries at a temperature lower than 0°C. This will increa the internal resistance to cau heat and make the batteries unstable and unsafe.
Plea u a battery temperature detecting device for a charger to ensure a safe
charging temperature range.
Storage and safety notice
Although the charged Lithium-Ion battery may be left unud for veral months, their capacity may be depleted due to build up of internal resistance. If this happens they will require recharging prior to u. Lithium-Ion battery may be stored at temperatures between -30°C to 70°C, however they may deplete more rapidly at higher temperatures. It is recommended to store batteries at room temperature.
