Reference number
ISO 5208:2008(E)鸡肉抓饭
震耳欲聋意思. ISO 2008
INTERNATIONAL
悲惨世界雨果STANDARD
灯的英语单词ISO
5208
Third edition
2008-08-01
天使的英文Industrial valves — Pressure testing of
metallic valves
Robinetterie industrielle — Essais sous pression des appareils de
robinetterie métalliques
禾花鲤ISO 5208:2008(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licend to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products ud to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for u by ISO member bodies. In
the unlikely event that a problem relating to it is found, plea inform the Central Secretariat at the address given below.
COPYRIGHT PROTECTED DOCUMENT
. ISO 2008
酒店大门All rights rerved. Unless otherwi specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Ca postale 56 ⎽CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail *****************
Web www.iso
Published in Switzerland
ii . ISO 2008 – All rights rerved
ISO 5208:2008(E)
. ISO 2008 – All rights rerved iii
Contents Page
iv
Introduction ....................................................................................................................................................... v
1 Scope .....................................................................................................................................................1
2 Terms and definitions ...........................................................................................................................1
3 Conditions relevant to 2
3.1 Purchar examination options ...........................................................................................................2
3.2
3.3 Closure pressure testing options ........................................................................................................3
4 Requirements for pressure testing ......................................................................................................3
4.1 Forewarning ..........................................................................................................................................3
4.2 Location .................................................................................................................................................3
4.3 Test equipment .....................................................................................................................................3
抒情的段落摘抄4.4 Pressure .3
4.5 3
4.6 Test fluid ................................................................................................................................................3
4.7 Test pressure ........................................................................................................................................4
4.8 Pressure tests .......................................................................................................................................4
