重阳节的来历和风俗
1.0PURPOSE：目的
To establish a standard test method for identifying sharp points. This applies to any outside point of any product which is made of metal, glass or hard plastic molding and to all internal points which can be contacted using the accessibility probes prior to and after u and abu testing.
建立了识别尖点的标准测试方法。本测试适用于包括金属、玻璃或硬质塑料的所有外部尖端以及使用和滥用测试前后可被可触及塞规接触到的所有内部尖端。
2.0SCOPE：范围
This is applicable to all products both before and after u and abu testing as required by the applicable Product Quality Requirement.
美女图片真实适用于按相应产品QR进行的使用和滥用测试前后的所有产品。
3.0 DEFINITIONS：定义
3.1Accessibility可触及性
3.1.1An accessible point is one that can be contacted by any portion
forward of the collar of either Probe A or B.
可被塞规A或B的颈圈前方的任何部位触及到的尖端。
4.0EQUIPMENT：设备
4.1Sharp Point Tester – (Reference Illustration # 1)
尖点测试仪—（参照图解1）
果桑苗4.2Accessibility Probes – (Reference Illustration # 2)
可触及塞规—（参照图解2）巴西最大城市
5.0PROCEDURE：程序
5.1TESTING FOR ACCESSIBILTIY 可触及性的测试
由于近义词
5.1.1Before and after u and abu testing, Impact, Torque, Tension,
Compression, and Bite u the Accessibility probes to determine if a
point can be contacted.白糕
使用和滥用测试、撞击、扭力、拉力、压力和咬力测试前后，用
可触及性塞规测定是否有可接触的边缘。
巴沙鱼片怎么做好吃又简单
5.1.2Inrtion Depth for accessibility 可触及性的插入深度
5.1.2.1For any hole, recess or opening having a minor dimension
生产事故调查报告
(the minor dimension of any opening is the diameter of the
largest sphere that will pass through the opening) smaller
than the collar dimension of the appropriate prove, the total
inrtion depth for accessibility shall be up to the collar on
the appropriate probe. Each probe joint may be rotated to
90° to simulate knuckle movement.
最小直径小于相应塞规的颈圈的任何孔洞、凹处或开口，相应塞
规的插入深度应直到其颈圈处。每个塞规的连接处应旋转90°以
模仿关节的运动。
5.1.2.2For any hole, recess or opening having a minor dimension
of 7.36 inch or larger when Probe A is ud or a minor
dimension of 9 inch or larger when Probe B is ud, the
total inrtion depth for accessibility is unrestricted.
