米其林轮胎技术用语词典（Michelin tyre technical dictionary）
米其林轮胎技术用语词典(Michelin tyre technical dictionary)
Pressure | Air Pressure
The internal air pressure of the air per square inch is the "pound per square inch" (PSI) or the air pressure metric "kPa".
Four-wheel positioning | Alignment
保鲜箱Adjust all the wheels on the vehicle, make it relative to the road and the best direction of each other, and the four-wheel position will cau the tire to wear out and shorten the life of the tire. 戈雅法餐厅
All ason tyres | all-ason tyres
It provides a good balance of traction in the rain and snow, and has a good life of tread pattern, comfortable and quiet tires. Winter tires are recommended for maximum safety in w
inter and snow roads
The water float is | Aquaplaning 超纤皮是什么
A very dangerous condition. The water in front of the tire caus the tire to lo contact with the road surface. At this point, the vehicle will be skidding on the water, completely out of control. This phenomenon is also known as hydroplaning.
Height Ratio | Aspect Ratio
The ratio of the tire side height to the width of the cross ction.
Asymmetric Tread pattern Design | Asymmetrical Tread Design (AD)
Using different patterns on both sides of the tread can enhance and optimize the operation performance of dry wetland. The tread pattern on the inside of the tyre has more horizontal grooves to facilitate drainage. And the outside
Balance/unbalanced | Balance/unbalance
Balance refers to the condition of the average weight distribution of a tire and rim when it is rotated. In the adjustment of the imbalance state, the trained technician will add a certain weight to the inner or outer rim of the rim.
Michelin BAZ technology? | Banded At Zero Technology?
Michelin? BAZ technique refers to the u of a spiral wound polyamide overlay in the upper tread area of a wire belt layer, which can resist the centrifugal force that can cau the tyre deformation when traveling at high speed. BAZ technology optimizes the speed control of vehicles and the durability of tires.
Skew cord fabric (tire) | Bias - Ply
A tire that USES the center line of the tread to cross the cord. word怎么删除一页
Bolt Circle (diameter) | Bolt Circle
Through the imaginary circle diameter of each nut hole center, the distance from the two r
elative holes in the circumference is obtained. This data can be ud when lecting the correct replacement rim.
External tilt Angle | Camber
The Angle of the rim on the inside or the outside is measured in degrees. In order to keep the outer surface of the tyre and the surface of the surface of the road, the Angle of the outside inclination should be adjusted. The abnormal wear of the tyre due to excessive Angle Angle or too small Angle will affect the life of the tyre.
External Thrust | Camber Thrust
The lateral force or lateral force produced when the tyre is rotated with the outer tilt, it can increa or decrea the lateral force produced by the tyre.
二极管检测
Carbon Black BBB 0 Carbon Black
烙铁温度
This is an enhanced additive that can enhance the wear resistance of the tire when added to the rubber formula.
Carrying Capacity | Carrying Capacity
The design of each tire can carry as much weight as the specific tire pressure. Each tire size has an inflatable filling table to ensure that the air pressure is sufficient to withstand the load on the axle.
Back Angle | Caster
The Angle between the vertical line drawn from the center line of the rim and the axle that controls the rim of the rim. Can improve the vehicle direction stability and the central direct line feeling.
Line | Centerline
An imaginary line down the centre of the vehicle. Location tracking is measured using this line.
Centrifugal Force | Centrifugal Force
The lateral acceleration of the object doing the curve motion is g. When the car is moving in a curved way, it will be affected by centrifugal force and pull it outward. To counteract the centrifugal force, the tires will produce the same reaction force on the road. Also called "lateral force". 朝鲜世宗
Cold Inflation Pressure | Cold Inflation Pressure
The tire pressure measured before the tyre is driven by the heat, the unit is a pound/square inch (psi).
Ground | Contact Patch
The area where the tyre is in contact with the road surface. Also called "footprints".
Turn to Force | Cornering Force
The steering force generated by the steering wheel is able to keep the vehicle moving along the desired arc.
Cross Z small groove Technology | Cross z-sipes Technology
A small grooved pattern that can provide transver and longitudinal rigidity in the tread pattern.
Vehicle gearing Weight | Curb Weight
The weight of the vehicle with a full tank (including the tank) and all normal equipment, but not the driver and pasnger.
Qu torsion | Deflection
When the tread is expod to the road surface, the curvature of the side of the tire is distorted.
