Mechanical dry / moist standard
Tensile strength at yield95MPa DIN EN ISO 527
Elongation at yield5%DIN EN ISO 527
Tensile strength at break MPa
Elongation at break25%DIN EN ISO 527
Modulus of elasticity in tension3000MPa DIN EN ISO 527
Modulus of elasticity after flexural test4100MPa DIN EN ISO 178
Hardness M99ASTM D 785
Impact strength 23º C(Charpy)n.b.KJ/m²DIN EN ISO 179 (Charpy)
MPa
Creep rupture strength
after 1000 h with static load
Time yield limit
MPa
for 1% elongation after 1000 h
xoyo0,30−0,38
Co−efficient of friction
p = 0,05 N/mm²v=0,6 m/s
九年级上册英语作业本答案
圣诞节快乐英文翻译on steel, hardened and ground
µm/km
Wear
packing list
p = 0,05 N/mm²v=0,6 m/s
on steel, hardened and ground
Thermal dry / moist standard
Crystalline melting point343°C DIN 53 765
Glass transition temperature143°C DIN 53 765
Heat distortion temperature
140°C ISO−R 75 Verfahren A (DIN 53 461) HDT, Method A
182°C ISO−R 75 Verfahren B (DIN 53 461) Heat distortion temperature
HDT, Method B
Max. rvice temperature
short term300°C
long term260°C
Thermal conductivity (23º C)0,25W/(K·m)
grenadeSpecific heat (23º C)0,32J/g.K
5,010−51/K DIN 53 752
Coefficient of thermal expansion
(23−55ºC)
Electrical dry / moist standard
Dielectric constant (106 Hz)3,2−3,3DIN 53 483, IEC−250
Dielectric loss factor (106 Hz)0,001−0,004DIN 53 483, IEC−250
Specific volume resistance10^16*cm DIN IEC 60093
tippingSurface resistance10^15DIN IEC 60093
Dielectric strength20kV/mm DIN 53 481, IEC−243, VDE 0303
Teil 2imitate
Resistance to tracking
Miscellaneous dry / moist standard
Density1,30g/cm3DIN 53 479
0,1%DIN EN ISO 62
Moisture absorption
(23°C/50RH)
Water absorption to equilibrium0,5%DIN EN ISO 62
Flammability acc. to UL
V0四级核心词汇
standard 94
contests
(1) Testing of mi−finished products
aino
The above information corresponds with our current knowledge and indicates our products and possible applications. We cannot give a legally binding guarantee of chemical resistance, of certain properties and the suitability of our products and their applications. Our products are not destined for u in medical and dental implants. Existing commercial patents must be obrved. Unless otherwi stated, the values reprent averages taken from injection moulding samples, dry as moulded. We rerve the right to make technical alterations.
