java中英文翻译
Characteristics of LANs
The main Characteristics of a LAN include its throughput,delays,wiring type and distances,curity,and reliability.We discuss the characteristics below.We then compare the characteristics of major LANs.
Throughput
The throughput is the average total transmission rate when the LAN is heavily loaded by many nodes.
In a shared LAN,the throughput is a fraction of the rate of the transmitters.This fraction is called the efficiency of the MAC protocl.For insyance,a network that us a MAC protocol with an efficiency oh 65 percent and 10-Mbps transmitters has a throughput of 6.5 Mbps.The values are typical for a shared 10-Mbps Ethernet.The throughput of a token ring network and that of FDDI are clo to their thransmission rate. Latency
The latency is the time a packet takes froms its arrival at anetwork interface until it reaches the destination node.We explain in Section 4.8that this latency is almost aiways less than a fraction of a cond and is often much smaller.
Wiring Type and Distance面试自我介绍ppt实例
Some LANs u twisted wire pairs,others u optical fibers,Older LANs and installations in special environments u coaxial cables.The maximum length of the connections depends on the LAN and on the techanology.Typical values are 100 m for twisted pairs and a few kilometers for multimode fibers.
Security
Anoptical fiber is more difficult to tap into than a twisted pair,which improves the “physical”curity.However,eavesdroppers rarely need to tap directly into a link to gain access to information.A more common attack
is to u one of the computers attached on the LAN and configure it to read all the packet
mipro
s that travel on the network(this is called snooping).If nsitive pieces of information such as ur passwords are transmitted in the clear(nonencrypted),then the eavesdropper obtains entry points into computers.As a rule,a switched LAN is more cure than a shared LAN becau a computer on such a network es only the packets intended for it.
Reliability
We depend increasingly on networks.Accordingly,reliability becomes more esntial.As we mentioned in the opening remarks of this chapter,FDDA is designed to survive a link or node failure.An Ethernet keeps on working when some of its nodes or links fail.Atoken ring network can be wired with bypass electronics to have a similar reliability.
Network Devices
fault是什么意思Text
There are many types of media for the network, and each one has advantages and disadvantages. One of the disadvantages of the type of cable that we primarily u (CAT
5 UTP) is cable length. The maximum length for UTP cable in a network is 100 meters (approximately 333 feet). If we need to extend our network beyond that limit, we must add a device to our network. This device is called a repeater.
The term repeater comes from the early days of visual communication, when a man situated on a hill would repeat the signal to the person on the hill to his right. It also comes from telegraph, telephone, microwave, and optical communications, all of which u repeaters to strengthen their signals over long distances, or el the signals will eventually fade or die out.
make it up
The purpo of a repeater is regenerate and retime network signals at the bit level to allow them to travel a longer distance on the media. Watch
out for the Four Repeater Rule for 10Mbps Ethernet, also known as the 5-4-3 Rule, when extending LAN gments. This rule states that you can connect five network gments end-to-end using four repeaters but only three gments can have hosts (computers) on them.
褫夺公权
nervous广州达内培训The term repeater traditionally me ant a single port “in” and a single port “out” device. But in common terminology today the term multiport repeater is often ud as well. Repeaters are classified as Layer 1 devices in the OSI model, becau they act only on the bit level and look at no other information. The symbol for repeaters is not standardized.
The purpo of a hub is to regenerate and retime network signals. This is done at the bit level to a large number of hosts (e.g.4,8, or even 24) using a process known as concentration. You will notice that this definition is very similar to the repeater’s, which is why a hub is also known as a multi-port repeater. The difference is the number of cables that connect to the device. Two reasons for using hubs are to create a central connection point for the wiring media, and increa the reliability of the network. The reliability of the network is incread by allowing any single cable to fail without disrupting the entire network. This differs from the bus topology where having one cable fail will disrupt the entire network. Hubs are considered Layer 1 devices becau they only regenerate the signal and broadcast it out all of their ports (network connections).
学习意大利语
figureoutE-commerce (Electronic Commerce, is abbreviated as E-commerce) employs the way on the basis of the browr / rver under the environment of Internet's open network, realize consumers' online shopping, online trade between the trade companies and a new kind of commercial operation modes paid by mails online. E-commerce on Internet can be divided into three respects: Information rvice, trade and paying. The main content
includes: Electronic market conditions advertiment; The electron is chon and exchange of trade, electronic trade evidence; Paying by mails and ttling account and online rvice after sale,etc.. The main trade type is trade (C2C) of trade (B2B) and individual and man-to-man bet between enterpris and personal trade (B2C) and enterpri,etc.. JSP (Java Server Page) is that dynamic Web bad on that Java has nothing to do but with the platform develops technology, there is very high operational efficiency, development period is shorter, it is stronger to expand ability, have opening, step the platform, expandability and reusable characteristic. JAVABEAN is kind of a kind of Java, become through encapsulating and have a certain function or target of dealing wi
th a certain business, can visit Bean and method in JSP page Java code inside through inlaying. The online mobile phone store is a WEB application program bad on that JSP/JAVABEAN technology ts up, divide into 2 parts of goods show of the front desk and sale, back-stage management, It is a kind of typical B2C e-commerce mode, realize the main function of e-commerce.
incumbent
